KENWOOD PAW45001 Power Whisk Instruction Manual
- June 17, 2024
- KENWOOD
Table of Contents
AW45001
AW45002
PAW45001 Power Whisk
Your new Power Whisk has been fitted at the factory with a plain shaft as
shown in Figure A. However, your mixer may not be compatible with this design
and you may need to change the shaft for the additional one supplied.
Please look at the bowl tools supplied with your mixer and check which type of
shaft is fitted. If the shaft has a clip as shown in Figure B, you will need
to replace the shaft on the Power Whisk. Using a spanner loosen the nut on the
shaft 1 and then turn the shaft anti-clockwise until it is released. Replace
with the shaft with the clip fitted and tighten the nut.
Adjust the height of the Power whisk using the following procedure. For best
performance the whisk should be almost touching the bottom of the bowl 3.
- Unplug the mixer.
- Raise the mixer head and insert the whisk.
- Lower the mixer head. If the clearance needs to be adjusted raise the mixer head and remove the whisk.
- Using a spanner loosen the nut 1 sufficiently to allow adjustment of the shaft 2. To lower the whisk closer to the bottom of the bowl, turn the shaft anti-clockwise. To raise the whisk away from the bottom of the bowl turn the shaft clockwise.
- Re-tighten the nut.
- Fit the whisk to the mixer and lower the mixer head. Check its position 3.
- Repeat the above steps as necessary until the whisk is set correctly. Once this is achieved tighten the nut securely.
● Designed and engineered by
Kenwood in the UK
● Made in China
● This appliance conforms to EC directive 2004/108/EC on
Electromagnetic Compatibility and EC regulation no. 1935/2004 of
27/10/2004 on materials intended for contact with food.
service and customer care
UK
If you need help with:
-
using your appliance
-
servicing or repairs (in or out of guarantee)
call Kenwood customer care on 023 9239 2333. -
spares and attachments
call 0870 2413653.
other countries -
Contact the shop where you bought your appliance.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH
EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban
waste.
It must be taken to a special local authority differentiated waste collection
centre or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative
consequences for the environment and health deriving from inappropriate
disposal and enables the constituent
materials to be recovered to obtain significant savings in energy and
resources. As a reminder of the need to dispose of household appliances
separately, the product is marked with a crossed-out wheeled dustbin.
Head Office Address:
Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK
www.kenwoodworld.com
Designed and engineered by Kenwood in the UK
Made in China
19488/1
https://manual-hub.com/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>