HOPE YOU READY 2023 Tape On Window Deflectors Instruction Manual

HOPE YOU READY 2023 Tape On Window Deflectors Instruction Manual

Installation Manual (Front)

1. Lower car window and clean the channel with alcohol,
   

2. ‘Remove tape liner from the wind deflector Siide the front end edge of the wind deflector inside window channel (near the side mirror)
   

3. ‘Side the rear end edge into positon in the channel. Push in the Middie to fit the wind galacturonide the channel.
   

4. Use a screwdriver to put one ciip inside the window channel on the rear edge
   

5. Use & screwanver (o put one Ol snide the window channel on the front edge (fneeded).
   

6. Roll window up slowly to ensure that the wind deflector is n the right position
   

NOTE:

1. During the closing process, pull the wind deflector gently outwards at the rear.
2. If the window should have difficulty closing, support the process pressing in the window upwards with your hands.
3. Ifthe closing procedure fails, please repeat note 1 & 2.
4. Keep the window closed completely for 24h to guarantee adaptation to the window seal.

Installation Manual (Rear)

1. Lower car window and clean the channel with alcohol

2. ‘Remove tape liner from the wind deflector. Siide the front end edge of the wind deflector inside window channel,

3. Slide the rear end edge into position inside the channel. Push in the midd o fit the wind deflector inside the channel

   ---

4. Use a screwdriver to put one clip inside the window channel on the front edge.

5. Use a screwdriver to put one clip inside the window channel on the rear edge

6. Roll window up slowly to ensure that the wind deflector is n the right position

NOTE:

1. During the closing process, pull the wind deflector gently outwards at the rear.

2. If the window should have difficulty closing, support the process pressing in the ‘window upwards with your hands.

3. If the closing procedure fails, please repeat note 1& 2.

4. Keep the window closed completely for 24h to guarantee adaptation to the window seal

5. Why do you need to use clips?
   These go in the channel and help pressure-fit the visors in the window track. If you don’t use the clip to secure it, the rain guards will still fall out when you open the window even after 48 hours.

6. The function of the Clip:

7. If the window can’t open and close freely up and down or is stuck, you can use the snap to hold up the internal groove to open the gap.

8. It can also make the rain stopper more firmly stuck inside.

9. How to use the clip:
   the clip is a V-shape, the bottom faces inward, and the opening faces outward, as shown in the picture.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>