Everbloom E333618WU Rolling Elevated Garden Planter with Under Shelf Installation Guide
- June 1, 2024
- Everbloom
Table of Contents
Everbloom E333618WU Rolling Elevated Garden Planter with Under Shelf
Specifications
- Model: E333618WU
- Dimensions: 36 L x 18 W x 36 H
- Maximum Load Capacity: Approximately 2.2 cu. ft. of soil
Product Usage Instructions
Before You Start
- Read the instructions carefully to familiarize yourself with every detail and step involved.
- Find a suitable space with at least 37 x 19 inches for the finished product on a flat and firm area like a garage floor or flat yard space.
- Gather the necessary tools: a rubber mallet and a scissor.
Important Notes
- Keep small parts away from children and pets.
- Assemble with the help of another person.
Assembly Instructions
- Step 1: Start by ensuring each corner post is oriented correctly. Slide one short board into the corner brackets from above.
- Step 2: Slide another short board into the remaining two corner brackets from above.
- Step 3: With the help of another person, slide the two long supporting boards into the brackets from above. Ensure one support board reaches the bottom while the other stays in the middle.
- Step 4: Place the bottom trays on the lower slots of the long support boards, ensuring they rest securely. Adjust the height of the higher long support board if needed.
FAQ
Q: What is the maximum load capacity of the planter?
A: The maximum load capacity is approximately 2.2 cu. ft. of soil.
Q: Can I assemble the planter alone?
A: It is recommended to have another person help you assemble the planter for ease and safety.
Thank You!
You’re only a few steps away from your perfect vegetable garden or elevated planter. We hope you enjoy it!
Before You Start
- Please read the instructions carefully to familiarize yourself with every detail and step involved. Keep this manual for future reference. Find a suitable space to assemble your new Elevated Garden Bed.
- You need at least 37” x 19” (94 x 49 cm) for the finished product. A flat and firm area (like a garage floor or flat yard space) is perfect! The only tools you may need are a rubber mallet and a scissor.
Important Notes
- Small parts are included; we advise you to keep them away from children and pets.
- We also suggest having another person help you assemble. Maximum Load capacity: approximately 2.2 cu. ft. of soil
- Subscribe at www.everbloom-garden.com for extra savings and upgrading information!
- Everbloom-Garden.com
Questions or Comments?
- Email us at service@everbloom-garden.com
- Copyright © 2023 Dynaforge Trading LLC.
Parts List
Rolling Elevated Garden Planter with Under Shelf – 36″ L x 18″ W x 36″ H
Rolling Elevated Garden Planter with Under Shelf – 36″ L x 18″ W x 36″ H
Assembly
- Rolling Elevated Garden Planter with Under Shelf – 36″ L x 18″ W x 36″ H
- Start by making sure each corner post is oriented correctly, as shown in Image 1. Slide one short board into the corner brackets from above.
- Note: The short boards need to be placed in the inward “U” shape of the brackets, as shown in Image 1.
- Slide another short board into the other two corner brackets from above, as shown in Image 2.
- With the help of another person holding the 2 assembled parts, slide the 2 long supporting boards into the brackets from above.
- Make sure that one support board goes straight to the bottom, while the other one stays in the middle of the way (don’t push to the bottom), with the bottom edge between the 2nd and 3rd holes of the post, as shown in Image 3.
- Put the bottom trays on the lower slots of long support boards. Make sure the 2 ends of these bottom trays go into the lower slots and rest in them with enough contact as shown in Image 8.
- Adjust the height of the higher long support board slightly to hold these bottom trays if necessary.
- Push down the higher long support board to the bottom, as shown in Image 9.
- Carefully flip over the planter so that it lays flat with the short boards pointing towards the sky, as shown in Image 10.
- Open all the steel connector washers, as shown in Image 11.
- Then, clamp the connector washers onto the steel wire panel, as shown in Image 12.
- Note: Pay attention to the position and direction of the connector washer on the panel. Close all the connector washers, as shown in Image 13.
- Align the steel wire panel to four post brackets and fasten a connector washer on the steel wire panel to the post bracket with bolts and nuts, as shown in Image 14.
- Note: Pay attention to the direction of the connector washer on the panel. The bolts need to be inserted from the inside of the post.
- fasten the other three connector washers on the steel wire panel to post brackets with bolts and nuts, as shown in Image 15.
- Insert caster wheels into corner brackets, as shown in Image 16 and Image 17.
- Fix the wheels with bolts and nuts, as shown in Image 18.
- Fasten bolts and nuts with a nut driver and hex key which are included in the pack, as shown in Image 19.
- Flip over the planter again so it stands upright, as shown in Image 20.
- Seal the small gaps between reservoirs and the gaps between the reservoir and short boards with black tape, as shown in Image 21.
- Bottom trays come with 18 drainage holes each with end caps, enabling adjustable drainage settings.
- Take off some end caps in advance according to different climates and watering needs as you wish, as shown in Image 22.
- For example, in rainy seasons, you may remove more end caps for better drainage; for plants that have large water consumption, put the end caps back from the bottom to reduce water flowing away.
- Cover the holes with liners, as shown in Image 23.
- If necessary, use your rubber mallet to ensure the boards are tightly in place. Cover the brackets with the 4 end caps, as shown in Image 24.
- Now you get an EverBloom Rolling Elevated Garden Planter with Under Shelf, as shown in Image 25. Then, enjoy your gardening time!
- Sometimes there might be a misalignment of the Corner Posts as shown in Image 26 and Image 27, which may result in the difficulty of sliding boards into the brackets.
- Please adjust them to the right position so that they are parallel to each other and perpendicular to the ground.
- Bloom On.
- Everbloom-Garden.com
- US Patent Pending
- Subscribe atwww.everbloom-garden.com for extra savings and upgrading information!
- Distributed by:
- Dynaforge Trading LLC
- St. Paul, MN55101
- Email:service@everbloom-garden.com.
References
- Raised Garden Bed Kits | Elevated Planters – EverBloom Garden
- Raised Garden Bed Kits | Elevated Planters – EverBloom Garden
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>