audio pro ADDON T3 Wireless Portable Speaker User Manual
- June 3, 2024
- audio pro
Table of Contents
audio pro ADDON T3 Wireless Portable Speaker
BEFORE USING
Charge the battery fully before using the speaker first time.
CONTROLS
PAIR
REAR VIEW
CHANGE BATTERY
Only use Audio Pro original battery!
The warranty time for the battery is one year.
| This
equipment is a Class II or double insulated electrical appliance. It has been
designed in such a way that it does not require a safety connection to
electrical earth. Warning! Disposal of a battery into fire or a hot oven, or
mechanically crushing or cutting of a battery, that can result in an
explosion. Leaving a battery in an extremely high temperature surrounding
environment that can result in an explosion or the leakage of flammable liquid
or gas. A battery subjected to extremely low air pressure that may result in
an explosion or the leakage of flammable liquid or gas.
---|---
www.audiopro.com
© AUDIO PRO AB, SWEDEN. ALL RIGHTS RESERVED.
TRADEMARKS ARE THE PROPERTY OF AUDIO PRO AB, SWEDEN. Audio Pro AB,
Garnisonsgatan 52 SE-254 66 Helsingborg, Sweden
©1978-2020 Audio Pro AB Sweden. Audio Pro®, the Audio Pro logotype, the ‘a’
symbol, and ace-bass® are all registered trademarks of Audio Pro AB, Sweden.
All rights reserved. Audio Pro follows a policy of continuous advancement in
development. Specifications may be changed without notice.
All other products and services mentioned may be trademarks or service
marks of their respective owners.
THIS DOCUMENT CONTAINS INFORMATION THAT IS SUBJECT TO CHANGE WITHOUT
NOTICE.
The Bluetooth®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and
any use of such marks by AUDIO PRO AB, is under license. Other trademarks and
trade names are those of thier respective owners.
SPECIFICATIONS
| Type: | Powered portable stereo speaker with bass reflex |
|---|---|
| Battery: | Up to 30h (at 50% vol). 12h at 100% vol. |
| Amplifier: | Digital Class D amplifier, 2x5W + 1x15W |
| Tweeter: | 2 x ¾” textile dome tweeter |
| Woofer: | 1 x 3.5″ |
| Frequency range: | 60 – 20.000Hz |
| Crossover frequency: | 5.200Hz |
| Dimensions HxWxD | 115 x 215 x 135 mm |
| Inputs: | Bluetooth 4.0 + Aux In 3.5mm stereo |
| Outputs: | USB DC OUT/max 5V 1000 |
| Power consumption STBY/ON: | 0.38W-2.6W |
BOX CONTENTS
- 1 x ADDON T3+ Speaker
- 1 x Manual
- 1 x Power cable
|
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
|
---|---|---
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO
RAIN OR MOISTURE.
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
FCC
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS:
1 – THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
2 – THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
MODEL: T3. FCC ID: 2AGNC-T3 IC: 20967-T3
FCC WARNING
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.This
device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interferencethat may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC
This device complies with Industry Canada licenceexempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2)
This device must accept any interference, including interference that may
cause undesired operation of the device.
IMPORTANT SAFETY INSTRUCTIONS
-
Read these instructions.
-
Keep these instructions.
-
Heed all warnings.
-
Follow all instructions.
-
Do not use this product near water.
-
Clean only with dry cloth.
-
Operating temperature (˚C) 5–40 Humidity (%) no condensation 30–90
-
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
-
Minimum distances around the product for sufficient ventilation, 10cm.
-
The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.
-
Do not install near any heat sources such as radiators, heat registers, stoves, or other product (including amplifiers) that produce heat.
-
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the product.
-
Only use attachments/accessories specified by the manufacturer.
-
Unplug this product during lightning storms or when unused for long periods of time.
-
Refer all servicing to qualified service personnel.
Servicing is required when the product has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the product, the product has been exposed to rain or moisture, does not operate normally, or has been dropped. -
Damage Requiring Service
Unplug the product from the wall outlet and refer servicing to qualified service personnel under thee following conditions:
A. When the power-supply cord or plug is damaged,
B. If liquid has been spilled, or objects have fallen into the product,
C. If the product has been exposed to rain or water,
D. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation,
E. If the product has been dropped or damaged in any way, and
F. When the product exhibits a distinct change in
performance this indicates a need for service. -
Object and Liquid Entry
Never push objects of any kind into the product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. The product shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases shall be placed on the product. No naked flame sources such as lighted candles etc., should never be placed on the product. -
Batteries
Always consider the environmental issues and follow local regulations when disposing of batteries. -
Make sure that there is adequate ventilation if you install the product in confined spaces, such as bookshelves or racks. Leave a distance of
20 cm above and on both sides of the product and 10 cm behind it. The back end of a shelf or board closest to the top of the product should be pushed forward to give a gap of about 10 cm behind. In this way an exuding channel is formed where heated air can flow up. -
The power supply and power cord for this product is intended for indoor use only.
-
Use only the supplied power cord/adapter.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>