Aqua-Scope ACCBVS02 Ball Valve Actuator Instruction Manual
- June 1, 2024
- Aqua-Scope
Table of Contents
Aqua-Scope ACCBVS02 Ball Valve Actuator
Product Specifications
- Product Name: Ball Valve Actuator (BVS*****)
- SKU: ACCBVS02
- EAN: 4251295783536
Product Usage Instructions
Installation Requirements
Ensure the following installation requirements are met:
- Properly align the valve center with the pipe.
- Contact support at support@aqua-scope.com for assistance with special cases.
Elbow Doctor Usage
If the pipe bends between 35 and 90 mm from the valve center, the Elbow Doctor can aid in installation on a bent pipe.
Frequently Asked Questions
Q: What should I do if my pipe bends at an angle greater than 90 mm from the valve center?
A: In such cases, please contact our support team at support@aqua- scope.com for further guidance on alternative installation methods.
Installation requirements for ball valve actuator (BVS*****)
To install the ball valve actuator, certain mechanical conditions must be met:
- Distance from the center of the pipe to the wall behind the pipe: at least 35 mm.
- All structures (wall, pipes leading upward/downward from the boiler) must be at least 80 mm away from the valve’s pivot point on both the right and left sides.
- On a stretch between 25 and 90 mm away from the center of rotation, there must be a structure on both sides narrower than 34 mm in diameter over a length of at least 25 mm to secure the motor using the adjustable clamps.
Special Cases: If necessary, contact our support at support@aqua- scope.com, who will assist you.
-
Elbow Doctor SKU: ACCBVS02 EAN: 4251295783536
If the pipe bends between 35 and 90 mm from the valve center, the “Elbow Doctor” allows installation even on a bent pipe. -
25 mm Spacer SKU: ACCBVS04 EAN: 4251295783567
If the lever of the ball valve is strongly angled upwards and higher than the standard ball valve, a 25 mm spacer can be installed between the adjustable clamps and the main device. -
Adapter for Double-Sided Ball Valves SKU: ACCBVS01 EAN: 4251295783529
Some ball valves are operated not with a long lever but with two relatively short levers. In this case, the coupling fork of the ball valve actuator may not correctly grip the two short levers, or there may be no central nut for adjusting the pivot point. The fork is then replaced by a special adapter. -
Adapter for Gerberit Ball Valves SKU: ACCBVS03 EAN: 4251295783550
New Gerberit ball valves require a special metal adapter that is screwed directly onto the brass axis of the valve after the – usually blue or green – lever has been unscrewed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>