CORN K755 2.4G Wireless Keyboard User Manual

CORN

2.4G Wireless Keyboard

PACKING LIST

Keyboard xl
Mouse x1
USB Receiver (Stored in the battery compartment) xl
User Manual xl

INSTRUCTIONS

1. Take out the keyboard and mouse from the package, and take out the USB receiver from the battery compartment of the mouse.
2. Put 2pcs 1 5V AAA dry cells into the keyboard with the correct polarity direction, and turn on its switch.
3. Put a 1.5V PA dry cell into the mouse with the correct polarity direction_
4. 1Plug the USB receiver in the computer port
5. They are available after the drive is installed on the computer automatically.

COMBINED MULTIMEDIA FUNCTIONS

INDEPENDENT MULTIMEDIA BUTTONS

Note :

1. The multimedia functions of the keyboard are not available in Mac OS
2. The keyboard is only workable with AAA alkaline dry cell and the mouse is only workable with AA alkaline dry cell. For better maintenance. please take out batteries if you’re not going to use the products for a long time.

SOLUTIONS FOR CONNECTING PROBLEMS

Mouse

1. Take out the battery and install it back with the correct polarity direction.
2. Press the left button, scroll wheel, and right button simultaneously over 3s and it will enter code pairing mode.
3. Unplug the USB receiver and replug it back.
4. Move the mouse within 20s and it works normally indicating successful code pairing.

Keyboard

1.  Turn on the switch after the keyboard is installed with batteries
2. simultaneously press and -4′)” buttons over **esc**. and the keyboard will enter into code pairing mode after its indicator light stays on.
3. Plug USB receiver in computer port and keep the distance between receiver and keyboard within 30cm.
4. The indicator light of the keyboard will go out if the code pairing is successful.

Note If the product is still unworkable after the above solutions, please repeat those steps for code pairing again. If your problems can’t get solved yet after that. please contact our customer service for help (Email support, visiting corn).

Warning :
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE ：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
FCC STATEMENT:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>