mAXPEENINGRODS LK-AB-SIL-0110-VLC Air Spring Kit Installation Guide

mAXPEENINGRODS LK-AB-SIL-0110-VLC Air Spring Kit

AIR SPRING BAG KIT LIST

Mounting brackets

Air Spring Bag and Airline

All Hardware kits

PRE-INSTALLATION INSTRUCTION

• This product will not increase the load capacity of your vehicle.
• Do not exceed the manufacturer’s recommended weight limit.
• The installation process may require drilling, professional installation is recommended to ensure personal safety.
• All modifications must be installed by qualified personnel and in compliance with your local modification regulations.

INSTALLATION GUIDE

ASSEMBLING THE AIR SPRING

NOTE:
Use “A” when installing on the driver’s side and use”B” when installing on the passenger’s side.

REMOVING THE JOUNCE BUMPER AND PLACING THE ASSEMBLY ON THE AXLE

STEP 1.
Raise the vehicle and support it in a way, using safety stands or equivalent, that the axle can be safely dropped away from the frame. This will need to be done for the air spring assemblies to be put into position between the axle and frame.

STEP 2.
Unbolt and remove the jounce bumper from the frame.

STEP 3.
Place the assembly on the strike plate with the legs of the lower bracket on either side of the axle.

INSTALLING THE UPPER BRACKET

• STEP 1.
  The air fitting points to the rear of the driver’s (left) side and the front of the vehicle on the passenger’s (right)side.

• STEP 2.
  Push the axle up so that the Upper mounting bracket (2 of the Air spring bag kit list ) can be bolted to the frame with the Hex bolt (10 of the Air spring bag kit list)

INSTALLING THE LOWER BRACKET

STEP 1.
Adjust the assembly so that the air spring is perpendicular to the bottom and top mounting brackets without twisting.

STEP 2.
Install the Fastening block (4 of the Air spring bag kit list) to the axle and Lower mounting bracket (1 of the Air spring bag kit list )with the Carriage bolt (9 of the Air spring bag kit list), washer and lock nut.

INSTALLING THE BRAKE LINE BRACKET (DRIVER’S SIDE ONLY)

• Install the brake line bracket to the lower bracket using the previous lower bracket bolts, washers and lock nuts.

INSTALLING THE HEAT SHIELD (PASSENGERJIS SIDE ONLY)

• Install the Heat shield (25 of the Air spring bag kit list )where it is closest to the passenger’s(right) side air spring.

Note:
Must slide the airline protective sleeve over the airline near the exhaust port.

INSTALLING THE AIRLINES

• Cut the air line appropriately and push the hose into the fitting then pull back and make sure it’s locked in place.
• Install the inflatable valve in a selected location, usually on the license plate at the vehicle’s rear.

CHECK AIR TIGHTNESS

Put some air into the air spring bag and spray a soapy solution on all connections and valves while checking for exiting air bubbles.

INSTALLATION COMPLETED

WARNING
Cancer and Reproductive Harm www.P65Warnings.ca.gov.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>