ORIGINAL GARAGE C-CB-11-BK OG Rear Crash Bar Installation Guide
- June 1, 2024
- ORIGINAL GARAGE
Table of Contents
C-CB-11-BK OG Rear Crash Bar
OG Rear Crash Bar for Harley-Davidson Bagger Installation Instructions-1.0
-
Remove the seat, both side covers, and both saddlebags. If the bike is equipped with seat bumpers, remove them as well.
-
Using a T45 socket, a T40 socket, a 9/16” wrench, and a 1/2” wrench, remove the bag rail.
Make sure to keep all the hardware we will be reusing them for the install -
Reinstall the small OEM bolt and nut in its original hole using the T40 socket and 1/2” wrench.
Torque this bolt to 15-ft-lbs
Note that the rear crash bar will not use this bolt. Refer to the picture for the bolt and the location it must go back to. -
Install the rear crash bar:
• Using a 7/32” Allen socket, screw in the included FHCS 3/8”-16×1 bolt first into the threaded hole in the top of your frame (under the seat).
• Install the OEM shortest torx screw in the center hole of your frame.
• Lastly, screw in the second OEM torx screw at the rear of the bike through the subframe. (Longest bolt)
• Please refer to the picture for the order in which to install the hardware -
Torque all three fasteners to 30 ft-lbs
-
Repeat steps 2 and 3 for the other side of the bike.
-
Reinstall side covers, saddlebags, and seat.
-
Install your slider tips.
-
Enjoy!
Need help?info@originalgaragemoto.com
OG Rear Crash Bar for Harley-Davidson Bagger
Installation Instructions-1.0OG Rear Crash Bar for
Harley-Davidson Bagger Installation Instructions-1.0
Documents / Resources
|
ORIGINAL GARAGE C-CB-11-BK OG Rear Crash
Bar
[pdf] Installation Guide
C-CB-11-BK OG Rear Crash Bar, C-CB-11-BK, OG Rear Crash Bar, Rear Crash Bar,
Crash Bar, Bar
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>