PerformanceDIY 300 Poly Instruction Manual

: June 1, 2024
: PerformanceDIY

Table of Contents

PerformanceDIY 300 Poly
Product Information
Product Usage Instructions
OVERVIEW
Install spike shoes
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PerformanceDIY 300 Poly

PerformanceDIY-300-Poly-product

Product Information

Specifications

Product Name: Poly 300
Mix Ratio: 1 to 1 by volume
Recommended Application: Industrial & Commercial Surfaces
Non-Skid Additive: PerformanceDIY.com non-skid additive for slip resistance
COEFFICIENT FRICTION: OSHA recommended 0.5

Product Usage Instructions

Step 1: Install Spike Shoes
Ensure spike shoes are properly installed before starting the application process.

Step 2: Mixing
Mix Poly 300 thoroughly for 2 minutes at a 1 to 1 ratio by volume.

Step 3: Application

Starting in the farthest corner of the room, pour all mixed contents parallel to the wall.
Cut in the perimeter walls or obstructions using the kit brush.
Draw the poly from the back wall using the kit squeegee until no wet poly remains.
Roll the poly with the kit roller until even and consistent.
Repeat steps for additional batches if needed.

Frequently Asked Questions (FAQ)

Q: What is the recommended use for Poly 300?
A: Poly 300 is recommended for industrial and commercial surfaces such as garage floors, basement floors, deck & patio surfaces, driveways, paver coatings, counter tops, and concrete patches.
Q: How do I achieve a slip-resistant surface with Poly 300?
A: To create a slip-resistant surface, use PerformanceDIY.com non-skid additive as per industry standards. This will provide a proper OSHA recommended 0.5 COEFFICIENT FRICTION for slip resistance.

OVERVIEW

PerformanceDIY-300-Poly-2

Install spike shoes

Note: Mix ratio is 1 to 1 by volume.

Step 1:
Pour ½-gallon contents of Part “A” Poly 300 into the large clean black container.
Step 2:
Pour ½-gallon contents of Part “B” into the same large clean black container.
Step 3:
Mix thoroughly for 2 minutes
Step 4:
Starting in the farthest corner of the room, pour all mixed contents (parallel to and approx. two feet from the wall”). Using the kit brush, cut in the perimeter walls or any other obstruction that may be hard to roll.
Step 5:
Using the kit squeegee, (perpendicular to the poured line of mixed Poly 300) draw the poly from the back wall with the squeegee until there is no longer wet poly to draw back. Continue to squeegee pulling this product down the line until complete.
Step 6:
With the kit roller, perpendicular to the squeegee application, roll the poly until even and consistent.
Repeat steps for additional batch applications
Step 7:
After the second section is squeegeed and rolled, go back and re-back roll entire floor completely

If you desire to have aluminum oxide nonskid added to the floor broadcast aluminum oxide non-skid over the floor in lesser amounts (only in the previous section which has been back rolled a 2nd time). Taking a pinch amount apply by throwing the non-skid into the air a minimum of 5′ or higher. Re-bounding the non-skid off the ceiling is a good idea to get even coverage.

Note: Aluminum oxide will make the floor more slip-resistant but will make it harder to clean; it should be used according to your desired needs. PerformanceDIY.com non-skid additive is industry standard and accepted means for creating a proper recommended OSHA 0.5 COEFFICIENT FRICTION slip-resistant non-skid surface.

Surface Coatings: