OZZ XR2 P9 LED Driving Light Installation Guide
- June 15, 2024
- OZZ
Table of Contents
OZZ XR2 P9”
88101 (black)
88102 (white)
Before installation
- Check the local laws and regulations and the region your vehicle may travel to for Auxiliary light before installation, ensure they are compliance.
- Read all installation instructions.
- Make sure the dimension and weight of the lamps and device are matched to your vehicle.
- Slight moisture inside may occur, it will be removed out from the vent after 2-4 time working.
- Working Voltage: 10-35V.
Mounting
- Determine the installation location, use a 11 mm drill 1 or 3 holes, lock nut tightening.
- Use the stay bar if it is needed for stabilization, see figure 02.
Wiring connections & Functions
-
Wiring connections
Black: Ground,
Red: Driving light for Off road
Blue: Driving Light on road (Emark)
White: White position light
Yellow: Amber position light -
Wiring Harness, 40A relay, 30A fuse.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>