rollodin DK-5068 Roller Blind with Battery Motor User Guide

rollodin DK-5068 Roller Blind with Battery Motor

Product Information

Specifications:

• Product Name: Eve MotionBlinds Roller Blind with Battery Motor
• Power Input: 5V USB-C
• Charging: Standard 5V USB-C cable
• Control: Eve App
• End Position Button: Yes

Product Usage Instructions

Setup Guide:

1. Activate the blind by connecting a standard 5V USB-C cable (e.g., your iPhone charger).
2. Download the Eve app.
3. Charge the blind using a standard 5V USB-C cable.

Mounting Instructions:

1. Install your roller blind by following the steps below:
2. Ensure the dimensions for mounting are as follows:

  * Minimum 15mm clearance on each side
  * Fabric width + approximately 10mm
  * Minimum 15mm clearance at the bottom
  * Maximum 3.5mm clearance at the top
2. Attach the necessary components according to the provided instructions.
3. Click into place securely.

LED Indicator Status

• LED blinks red: battery is charging.
• LED blinks green: battery is being charged.
• LED is solid green: battery is fully charged.

Mounting Instructions for Battery-Operated Roller Blind

1. Install your roller blind by clicking the blind into the bracket as shown in the diagram.
2. Ensure that the antennas do not get pinched during mounting.

Mounting Hardware

• 2x brackets
• 2x bracket covers
• 2x winding wheels
• 4x screws
• Required clearance: min. 15mm above window, fabric width + approx. 10mm on each side, min. 15mm below window.
• Maximum drill size: 3.5mm.
• Tools needed: Screwdriver, drill, drill bit, and potentially a hammer.

Attention

Always leave a round of fabric on the tube to ensure that the fabric does not fall off.

FAQs

• Q: How do I reset the blind?
  • A: To reset the blind, press and hold the reset/programming button for 5 seconds until the LED indicator flashes.
• Q: Can I control multiple blinds with one Eve app?
  • A: Yes, you can control multiple blinds individually or as a group using the Eve app.
• Q: How do I activate the roller blind?
  • A: Connect a standard 5V USB-C cable to the blind for activation.
• Q: How can I charge the roller blind’s battery?
  • A: Use the USB-C cable to charge the battery. The LED indicator shows the charging status.
• Q: What should I do if the fabric does not roll up correctly?
  • A: Make sure to always leave a round of fabric on the tube to prevent it from falling off.
• Q: Can I manually control the roller blind?
  • A: Yes, there is an optional pull control for manual operation.
• Q: How do I add the roller blind to the Home app?
  • A: After installation, the blind will be automatically added to the Home app for control

“`

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>