NUUGARDEN ODT352BK Iron Splicing Dining Table Instruction Manual
- June 1, 2024
- NUUGARDEN
Table of Contents
NUUGARDEN ODT352BK Iron Splicing Dining Table
INTRODUCTION
Thanks for purchasing and trusting NUUGARDEN with your home decorating plans. This product is a piece of furniture designed and made by NUUGARDEN Corp. We are committed to R&D and innovation and creating the most exquisite and diverse outdoor series.
After unpacking and before every use, check whether the item shows any damage. In addition, check that you have all parts and hardware before assembly. If there is any damage, please do not use it and call customer service at 800-257-7108 or email [email protected]. If you do not have all the parts lists, have your dealer contact us and we will send them to you immediately.
This item of furniture is intended for indoor and outdoor use. Please take time to read and follow the instructions below. Then, use this item as described in this operating manual. We accept no liability for damage caused by improper use.
ASSEMBLY INSTRUCTIONS
CAVEAT
Note: Please only tighten any bolts once all bolts place correctly and the product is lying flat. If you tighten one bolt, it may cause other bolts to get out of position.
STEP 1
Attach the 2pcs of tabletop (A) using 2 washers (M), 2 screws (K) with an Allen wrench (N), then using 2 washers (M), 2 nuts (L) with the wrench (O) to connect the tabletop. Finally, use an Allen wrench and wrench to tighten the screws in the opposite direction. Do not over-tighten.
STEP 2
Attach the 4pcs of legs (B) and 2pcs connection tubes (C) to the tabletop, using 12 screws (I). Do not over-tighten.
STEP 3
Fixed the support frame (D) to the connection tubes using 4 screws (J). Then put the 4 gaskets (E) into the support frame (D), using 8 screws (J) to attach the legs. Do not over-tighten.
STEP 4
Put the plastic parts (F) and (G) for the umbrella hole into the tabletop.
STEP 5
Put the umbrella cover (H) into the umbrella hole. Upon completing the entire assembly and bolting up, you can tighten down all screws.
CARE AND MAINTENANCE
Follow the instructions for the product’s material to ensure it stays in the best shape as long as possible. The information below is a general guideline. Don’t hesitate to get in touch with us to learn more.
- Only rinse it thoroughly with clean water to wash away dirt and grime. Never use abrasive cleansers on the furniture since they can attack the surface and leave behind scratch marks.
- For stubborn grime and stains, use a soft sponge and mild soapy water. Then dry it with a cloth or paper towel.
- Check the stability of the screws, nuts, and nut caps before each use. Then, tighten them up after one to two months’ use whenever required.
- Avoid improper use, and be careful not to scratch or damage the surface with sharp objects.
- When you move your furniture, lift it rather than pulling or pushing it to avoid damaging the floor, legs, and mounting.
NUUGARDEN USA
CUSTOMER SERVICE
Thanks for purchasing NUUGARDEN furniture. We are here to help you maximize
your enjoyment and appreciation of it. Please do not hesitate to contact our
customer service if you have any questions regarding assembly or accessories.
Add: 6366 Corley Road, Norcross, GA 30071.
Tel: 800-257-7108
Web: https://nuumart.com
E-mail: [email protected]
Service time: Mon-Fri, 8:30 AM-5:30 PM, EST
