HAMPTON BAY 25332 Someton 1 Light LED Pendant Fixture User Guide

HAMPTON BAY 25332 Someton 1 Light LED Pendant Fixture

Product Information

• Specifications:
  • Item #: 1010253122
  • Model #: 25332
  • Product Name: Somerton 1 Light LED Pendant Fixture

Product Usage Instructions

• Safety Information
  • Before you begin, make sure you carefully read and understand the instructions in this manual. Please follow the instructions in the order presented in this manual and observe all warnings and cautions.
  • WARNING: To reduce the risk of the fixture. Consult a qualified electrician before installation.
  • WARNING: Before beginning installation, turn off electricity at the circuit breaker box or the main fuse box.
  • WARNING: Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
  • WARNING: If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type to use as well as the electrical rating required.
  • CAUTION: All electrical connections must be in agreement with local codes, ordinances, or the National Electric Code (NEC).
  • CAUTION: Consult a qualified electrician before installation.
• Warranty
  • WHAT IS COVERED: The manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty contained herein.
  • WHAT IS NOT COVERED: The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including but not limited to any labour/expense costs involved in the replacement or repair of said product.

FAQs

• Q: What tools are required for assembly & installation?
  • A: Tools required for assembly & installation are not included. Please refer to the manual for a list of necessary tools.
• Q: How should I clean and maintain the pendant fixture?
  • A: Refer to the ‘Care and Cleaning’ section in the manual for detailed instructions on how to clean and maintain the pendant fixture.
• Q: What should I do if I encounter issues with the pendant fixture?
  • A: Refer to the ‘Troubleshooting’ section in the manual for guidance on resolving common issues. If problems persist, contact Customer Service for assistance.

Safety Information

Before you begin, make sure you carefully read and understand the instructions in this manual. Please follow the instructions in the order presented in this manual and observe all warnings and cautions.

• WARNING: To reduce the risk of the fixture. Consult a qualified electrician before installation.
• WARNING: Before beginning installation, turn off electricity at the circuit breaker box or the main fuse box.
• WARNING: Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury or death from electric shock.
• WARNING: If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type to use as well as the electrical rating required.
• CAUTION: All electrical connections must be in agreement with local codes, ordinances, or the National Electric Code (NEC). Contact your municipal building department to learn about your local codes, permits and/or inspections.
• CAUTION: Consult a qualified electrician before installation.

Warranty

WHAT IS COVERED

• The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for five (5) years from the date of purchase.
• This warranty applies only to the original consumer purchaser and only to products used in normal use and service.
• If this product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling.
• This warranty shall not apply to any product that is found to have been improperly installed, set up, or used in any way not per the instructions supplied with the product.
• This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, faulty installation, or any other failure not relating to faulty material or workmanship.
• This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear.

WHAT IS NOT COVERED

The manufacturer does not warrant and specially disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including but not limited to any labour/expense costs involved in the replacement or repair of said product.

• Contact the Customer Service Team at 1-855-HD-HAMPTON or visit WWW.HAMPTONBAY.COM.

Pre-installation

TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (NOT INCLUDED)

HARDWARE INCLUDED

NOTE: Hardware not shown to actual size.

PACKAGE CONTENTS

Operation

1. Preparing the mounting bracket
   • Unscrew the two support screws (short) (DD) from the mounting bracket (AA). Remove the mounting bracket (AA) from the canopy assembly (A) and keep the mounting bracket (AA) and two support screws (short) (DD) for later use.
2. Installing the mounting bracket
   • Fasten the mounting bracket (AA) onto the outlet box using two outlet box screws (long) (BB).
3. Adjusting the power cord and assembling the fixture
   • Screw the Center Threaded Rod (D) into the fixture body, and then screw the Cylindric Part (B) with the Tapered Tube (C) into the Center Threaded Rod (D). Make sure all parts are completely secure before proceeding.
   • Adjust the cord by loosening the set screw (FF) with
   • Flathead screwdriver (Not included) to desired length, and then tighten the set screw (FF) after adjusting.
4. Making the electrical connections
   • Strip 3/4 in. of insulation from the wire ends.
   • Connect the black wire from the fixture to the black wire from the outlet box, then connect the white wire from the fixture to the white wire from the outlet box.
   • The bare copper ground wire from the fixture must loop one turn under the head of the green ground screw (CC) on the mounting bracket (AA) before it is connected to the ground conductor of the supply circuit.
   • Cover the wires with wire connectors (EE). Tape the wire connectors (EE) and wires together, and carefully position all wires inside the outlet box.
5. Attaching the canopy assembly to the outlet box
   • Place the canopy assembly (A) over the outlet box, align the two holes of the mounting bracket (AA) and the canopy assembly (A), then tighten the support screws (short) (DD).

Maintenance

• Shut off the main power supply before performing any maintenance on the light.
• Wipe with a damp cloth or use window cleaner. Do not use abrasives.

Care and Cleaning

• To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the glass and surface of the fixture.
• To clean the inside of the fixture, first disconnect the power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
• Next, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the inside glass and interior surface of the fixture.
• Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft cloth to dust or wipe carefully.

Troubleshooting

the lamp.
The power is off.| Ensure the power supply is turned on.
There is a faulty switch.| Test or replace the switch.
There is a faulty wire connection.| Check the wiring.
The fuse blows or the circuit breaker trips when the light is turned on.| There are crossed wires or the power wire is grounding out.| Discontinue use of the lamp. Check the wire connections.

FCC

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. increase the separation between the equipment and the receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected, Consult the dealer or an experienced radio/TV technician for help.

• Caution: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
• Company Name: Lavery/Madison Avenue
• Company Address: 1151 Bradford Cir, Corona, CA 92882
• Telephone Number: 951-735-9220

Service Parts

(Pre-assembled to the mounting bracket (AA))

DD| Support screw (short)
EE| Wire connector
FF| Set screw

CONTACT

• Questions, problems, missing parts? Before returning to the store, call Home Decorators Collection Customer Service
• 8 a.m. – 7 p.m., EST, Monday – Friday, 9 a.m. – 6 p.m., EST, Saturday
• 1-855-HD-HAMPTON
• WWW.HAMPTONBAY.COM.
• Retain this manual for future use.
• Questions, problems, missing parts? Before returning to the store, call Home Decorators Collection Customer Service
• 8 a.m. – 7 p.m., EST, Monday – Friday, 9 a.m. – 6 p.m., EST, Saturday
• 1-855-HD-HAMPTON
• WWW.HAMPTONBAY.COM.

THANK YOU

• We appreciate the trust and confidence you have placed in the Home Decorators Collection through the purchase of this lighting fixture.
• We strive to continually create quality products designed to enhance your home.
• Visit us online to see our full line of products available for your home improvement needs.
• Thank you for choosing the Home Decorators Collection!
• Item # 1010253122
• Model # 25332
• WWW.HAMPTONBAY.COM.
• Please contact 1-855-HD-HAMPTON for further assistance.

References

• Home Decorators Collection - Home Decor - The Home Depot

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>