ACEMINING 5FT Barn Door Hardware Kit Instruction Manual

June 1, 2024
ACEMINING

Product Installation
Instructions GuideACEMINING 5FT Barn Door Hardware
Kit Barn door hardware
customerservice@aceminingus.com
aceminingus.com

Tools Needed

ACEMINING 5FT Barn Door Hardware Kit - Tools

Product Content

ACEMINING 5FT Barn Door Hardware Kit - Product

Measurements

ACEMINING 5FT Barn Door Hardware Kit - Product 1ACEMINING 5FT Barn Door Hardware Kit -
MasermentsConnect two rails together (If the rail is one piece please skip this step).
Place the rail against the wall, and use a pencil to mark where the holes should be.
Make sure the height of holes on the wall is H+111/16”.ACEMINING 5FT Barn
Door Hardware Kit - Maserments 1We provide 2 kinds of screws for you to install rail onto concrete wall or drywall.
A Concrete wall Installation.
Install the anchor to holes on the concrete wall first, then install lag bolt to anchor.
(When the length of the wall spacer is insufficient, this accessory can be used to extend it.) B Drywall Installation.
Install the lag bolt to wood stud or head board directly.ACEMINING 5FT Barn
Door Hardware Kit - Maserments 3Insert door stoppers into rail.
Install door stoppers between A-B and C-D.
Door stopper is used to prevent the hangers coming out of the rail.ACEMINING
5FT Barn Door Hardware Kit - Maserments 4Install the hangers onto the door according to the measurement in the pictures below.
Maximum door thickness is 13/4”.
If your door’s thickness is less than 13/4”, please add some bolt washers or cut the long door bolts to a suitable length to fit the door. The rubber ends are used to protect the door from touching the rail when sliding the door.
You need to drill holes on the door top side, please drill the holes ½” away from the edge of the door.
Then install the rubber ends on the door.ACEMINING 5FT Barn Door Hardware
Kit - Maserments 6Hang the door over the rail. Turn the rubber ends approximately 180 degrees so that they are stuck between the door and the rail. Adjust the 2 door stoppers to find a suitable position, Use the hex key to screw the door stoppers in place.ACEMINING 5FT Barn Door
Hardware Kit - Maserments 9Install the floor guide. Put floor guide on the floor first to fix a suitable position and make a mark so that the tip of the floor guide can work well in the slot.
Use drill bit to drill holes on the floor where the mark is, and then install the floor guide.

Product Details

Door hardware kit includes

Picture| | | | | | |
---|---|---|---|---|---|---|---
| Rail| Hanger| Lag bolt| Wall spacer & accessories| Door Stopper| Rubber End| Floor Guide
5.0FT| 2.5 FT2| 2| 3| 3| 2| 2| 1
6.6FT| 3.0 FT
2| 2| 5| 5| 2| 2| 1
8.0FT| 4.0 FT*2| 2| 7| 7| 2| 2| 1
10FT| 3.E+73| 2| 7| 7| 2| 2| 1

  • The number of tracks and accessories varies from model to model.
    Please refer to the actual receipt.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals