POWER-POLE SA-0034-AL Anchor Mode Wireless Foot Button Instruction Manual

June 1, 2024
POWER-POLE

POWER-POLE SA-0034-AL Anchor Mode Wireless Foot Button

TOOLS

  • Fine-tip Marker
  • Electric Drill
  • 7/64” Drill Bit
  • 2 Phillips Screwdriver

INCLUDED HARDWARE

POWER-POLE-SA-0034-AL-Anchor-Mode-Wireless-Foot-Button-fig-
\(1\)

Check the area beneath where the Foot Button will be mounted to ensure there are no hoses, wires, lines, tanks, or other sensitive components.
STEP 1 Choose a flat surface with adequate space to mount the Foot Button.
STEP 2 Mark mounting holes using a fine-tip marker.
STEP 3 Drill mounting holes using a 7/64” Drill Bit.
STEP 4 Install (3) Screws A and tighten snug using a #2 Phillips Screwdriver.

IMPORTANT!
If installing to gel-coat, follow the drilling procedure in Appendix A in the Installation & Owner’s Guide to ensure you do not crack or chip the gel coat.

NOTICE
Tapered Side (Toward User)

USING THE ANCHOR MODE WIRELESS FOOT BUTTON

This foot button is used to toggle Anchor Mode on or off. Tap the button once to activate. Tap again to deactivate.

PAIRING PROCEDURE

Tap the and on the Hybrid Remote at the same time. This will open a 6-second pairing window (The MOVE will make a consistent tone and the 3 LEDs on the Head Unit will intermittently flash TEAL). Then, press the Foot Button you are pairing. The Navigation Head will beep twice, indicating pairing is complete.

NOTICE
To open the pairing window, the Hybrid Remote must be within 2ft. of the Move.

BATTERY REPLACEMENT

IMPORTANT!
When replacing the battery, ensure the Foot Button and the surrounding area are as dry as possible to avoid any moisture intrusion.

POWER-POLE-SA-0034-AL-Anchor-Mode-Wireless-Foot-Button-fig-
\(7\)

STEP 1 Insert a small, Flat Head Screwdriver into the notch to pry it apart.
STEP 2 Remove the battery from the holder on the Circuit Board and replace it with any CR2032 3V Lithium Coin Battery.
STEP 3 Lay the Circuit Board flush in the Bottom Housing, ensuring it lays flat.
STEP 4 Lay the Foam Pad on the Circuit Board.
STEP 5 Insert the Plastic Disc into the Membrane. FIG 1
STEP 6 Install the Membrane to the Bottom Housing so the Tab goes into the Notch on the Bottom Housing. Make sure the Plastic Disc does not fall out. FIG 2
STEP 7 Reinstall the Top Housing so it snaps into place and there is no gap between it and the Bottom Housing. FIG 3

POWER-POLE-SA-0034-AL-Anchor-Mode-Wireless-Foot-Button-fig-
\(8\)

9010 Palm River Road, Tampa, Florida 33619 phone 813.689.9932 fax 813.689.8883 power-pole.com
Power-Pole is a registered trademark of JL Marine Systems, Inc. Copyright 2023 JL Marine Systems, Inc. All Rights Reserved.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals