Grand 1701299478 Bifold Doors Instruction Manual
- June 1, 2024
- Grand
Table of Contents
Grand 1701299478 Bifold Doors
Product Overview
Once you open your package, Identify the top frame before you install it.
If your door swing outward, the top frame inside is bigger than outside
RECOMMENDED TOOLS
Here are recommended tools and materials which are not supplied, but are necessary to ins all your Bifold Doors.
Phillips Screwdriver
|
Flathead Screwdriver
|
Screw
---|---|---
6′ Spirit Level or Laser Level
|
Allen Key
Cross Strings
|
Blue Painters Tape
|
Flashing
Foam Filler
|
Drill/SOS Hammer Drill
|
Safety Goggles/Glasses
Sill Pan
|
Drill Bit Index Set
|
SDS Drill Bit
Sealant
|
Counter Sink
|
Wood & Plastic Shim
NOTE: Ensure all sealants and materials used are compatible.
Step 1
Pre-Drill Frame Components
Bottom frame
Using drill bit, pre-drill install holes in bottom track locking channel. One
screw to be placed every 30″ on center.
Pre-Drill Frame Components
Top frame
Using drill bit, pre-drill install holes in top track locking channel. One
screw to be placed every 30″ on center.
Pre-Drill Frame Components
Side frame
Using drill bit, pre-drill install holes in side track locking channel. One
screw to be placed every 30″ on center.
Step 2
Joining the frame
Being Careful to protect all surfaces
Step 3
Site measurement
Measure the sizes again, make sure L 1 =L2=L3, W1 =W2=W3, 01 =02
Step 4
Site measurement
Install the aluminium frame into the opening, Check level (very important)
Step 5
Install the frame
Screw the frame into the opening.
Step 6
Install the Panel
Step 7
Install the connection frame
Step 8
Combine the sliding connection frame with the second panel
The place where the label is attached is facing down.
Step 9
Install the second Panel
Step 11Step 11
Repeat Step 9 and Step 10 until all the panels have been installed
Step 12
Test the Operation.
Step 13
Install the handle.
Step 14
Use sealant to seal the frame.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>