FIAMMA 02094-36A Bicycles Carrier Moterhome Cycle Rack Carrier Instruction Manual
- June 5, 2024
- FIAMMA
Table of Contents
FIAMMA 02094-36A Bicycles Carrier Moterhome Cycle Rack Carrier
Installation
Package contents
Check that nothing has been damaged or deformed during transport. In the event of doubts or questions concerning the installation, use, or limitations of the product, contact the dealer. We recommend that the installation is carried out by qualified personnel and in compliance with current local regulations.
-
Installation only on the right rear door
-
Not suitable for vehicles with a 270° hinge system
-
Before installation, make sure that the rear door is securely closed.
-
To check the compatibility of the Ducato Carry-Bike Frame with the windows of your vehicle
-
download the template from our website fi amma.com and follow the instructions.
Usage instructions
- Remove the first screw and replace it with X, Y, and J.
- Repeat the operation also with the other screws, but ALWAYS ONE A TIME.
-
Do not completely tighten the screws
-
Tighten the screws firmly
- Tighten the screws and ensure that the rear door opens and closes correctly.
WARNING!
Do not fully tighten the fork to the tube, leave 2mm space.
In case of problems please contact your local dealer indicating the data on the nameplate. Consult our website for spare parts drawing.
FCC Statement
- Read the following instructions and warnings carefully; failure to observe these installation and usage instructions as well as the laws for driving in the relevant country may cause severe harm or damage for which the manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the product must be installed.
- Checking that the wall/rear door is sufficiently solid and suitable for guaranteeing the resistance of the anchoring points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions are not guaranteed and it will be necessary to reinforce these points. After having positioned the Carry-Bike on the rear axle of the vehicle, the normal weight distribution on both axles would be modified. This variation must not exceed the maximum permissible axle load. Never exceed the maximum permitted length and the total weight of the full-load vehicle.
- Make sure that loading occurs following a correct weight distribution; it must be uniformly distributed (the heaviest bike must be placed near the wall of the vehicle) to ensure better stability. Always give warnings about the presence of the Carry-Bike on your vehicle, use a clear signal for leaning loads, and, in case of limited rear visibility, use the additional rear-view mirrors. Take into account the presence of the Carry-Bike, and pay attention during driving and especially during reversing maneuvers, particularly if you have a parking assist system. Always comply with speed limits and the Highway Code.
- The speed should always be suitable to traffic conditions and towed load. In case of use of the bike carrier with tow make sure that the tow hook is always accessible and the corner mobility of the tow is guaranteed (volume measuring din 74058). Check periodically the bicycle rack to make sure it is firmly attached, especially during the first kilometers after long trips to avoid damage to the Carry-Bike/vehicle. Make sure the belts are not loose and that the holding brackets have not shifted. Replace worn components immediately.
- During Carry-Bike installation, verify that there is enough distance between handlebars and/or pedals and the vehicle’s rear windows in order to avoid any damage to the window van; do not leave accessories attached (bay seats, baskets, etc) because vibrations could disengage bikes. In some cases, the rear windscreen wiper may not work due to the presence of bicycles. Be aware of the brush radius before operating the windscreen wiper.
- On this type of Carry-Bike, bike covers are not allowed (Bike Cover). It is advisable to remove the batteries from bicycles, before loading them on the Carry-Bike while traveling. The lower version must be used together with the number plate holder bar with regulation lights. The rear door opens even with bikes mounted. It is recommended to rotate the handlebars of bicycles to avoid damage to the vehicle wall, for which Fiamma declines all responsibility.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>