american lighting association 5702 Two Light Bath Vanity Instruction Manual

American Lighting Association 5702 Two Light Bath Vanity

Specifications

• Model Numbers: 5702, 5703, 5704-66A
• Maximum Wattage: Refer to the fixture’s specifications (DO NOT EXCEED)
• Socket Ring: #SKT-RING-26
• Mounting Plate: A-020-112180
• Components: Mounting Screw (2), Ground Screw (1), Glass G5703

Mounting the Fixture

Shut off the power supply at the fuse box or circuit breaker.

Connecting the Wires

1. Connect the electrical wires as shown in Fig. 2 making sure that all wire connectors are secured.
2. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting strap using the green screw provided.
3. Tuck wire connections neatly into the outlet box.

Your installation is now complete. Return power to the outlet box and test the fixture.

Note
The illustration in this manual is for installation purposes only and may not be identical to the fixture purchased.

WARNING!
SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.

MOUNTING THE FIXTURE (FIG. 1)

1. Shut off the power supply at the fuse box or circuit breaker. If necessary, remove the old fixture from the wall. Including the mounting hardware.

2. Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration.

3. Attach mounting plate (A) to outlet box (Not included) using outlet box screws (B). The side of the mounting plate marked “GND” must face out.

4. Attach fixture wall plate (C) over mounting plate (A) and secure with screws (D) tightly.

5. Place glass shade (F) over socket (E) and secure with socket ring (G)

6. Install the bulb (Not included) according to the fixture’s specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) (NE PASDEPASSER LA PUISSANCE NOMINALEMAXIMALE!).
   CONNECTING THE WIRES (FIG. 2)

7. Connect the electrical wires as shown in Fig.2 making sure that all wire connectors are secured. If your router box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting strap using the green screw provided.

8. Tuck wire connections neatly into the outlet box. Your installation is now complete. Return power to the outlet box and test the fixture.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>