Roykaw EZGO TXT Golf Cart Mat Full Coverage Floor Liner User Manual

Roykaw EZGO TXT Golf Cart Mat Full Coverage Floor Liner

E-Z-GO TXT / RXV

• EZGO TXT (1994-Up), Express S4 (2012-2020), Valor & Workhorse
• ZGO RXV (2008-Up) & 2Five (2009-Up)

Package Include

1 x Golf Cart Mat; 4 x Metal Clips; 1 x User Manual

Installation Guidelines

1. Lay the mat in the golf cart by going around the foot pedals carefully.
2. Positioning and tile the mat. Be patient and work the mat back and forth until it is flat around the pedals.
3. Look under the dashboard to find the edge of the factory flooring and pull the Roykaw mat and the factory flooring slightly away from the frame of the golf cart. As Image 01 showed, Take the short arm of the clip with the hooked edge and place that against the inside lip of the trim. With the long arm facing away from you toward the factory flooring and the short arm pressed against the lip of the trim, pull the factory flooring together with the mat and swing the clip around and slide it under the factory flooring. Press the flooring back down into place once it has been secured to the mat. The two mats will be clipped together.

NOTICE

1. The edge of metal if is ture, Plase re cartel the scrant your hand.
2. For clipped together perfectly, The metal clip be designed compact and maybe have a little tight. you need force to attach them together.
3. The Image 02 below just shows recommended metal clip locations, Not where it should be attached. The metal clips can place anywhere as your needs.

Club Car Precedent

• Club Car Precedent (2004-2022)
• Onward & Tempo (2017-2022), Villager & V4L (2019-2022)

Package Include

1 x Golf Cart Mat; 4 x Metal Clips; 1 x User Manual

Installation Guidelines

1. Lay the mat in the golf cart by going around the foot pedals carefully.
2. Positioning and tile the mat. Be patient and work the mat back and forth until it is flat around the pedals.
3. Look under the dashboard to find the edge of the factory flooring and pull the Roykaw mat and the factory flooring slightly away from the frame of the golf cart.
4. As Image 01 showed, Take the short arm of the clip with the hooked edge and place that against the inside lip of the trim. With the long arm facing away from you toward the factory flooring and the short arm pressed against the lip of the trim, pull the factory flooring together with the mat and swing the clip around and slide it under the factory flooring. Press the flooring back down into place once it has been secured to the mat. The two mats will be clipped together.

NOTICE

1. The sure of metal clap is ture, of be re castlin the scratch your hand.
2. For clipped together perfectly, The metal clip be designed compact and maybe have a little tight. you need force to attach them together.
3. The Image 02 below just shows recommended metal clip locations, Not where it should be attached. The metal clips can place anywhere as your needs.

CLUB CAR PRECEDENT

Club Car DS

Club Car DS (1982-2013) and Villager (1982-2018)

Package Include

1 x Golf Cart Mat; 4 x Metal Clips; 1 x User Manual

Installation Guidelines – Mat

1. Lay the mat in the golf cart by going around the foot pedals carefully.
2. Positioning and tile the mat. Be patient and work the mat back and forth until it is flat around the pedals. Align the top of the mat with the aluminum frame piece under the dashboard.
3. If you have a cup holder, Slide the mat behind the cup holder as well, you will have to slide the mat behind the 3 pins on the backside of the cup holder.
4. Keep the mat well situated and flat, and then install the metal clips in the recommended locations on the image 02 featured or wherever necessary to create a secure fit.

Installation Guidelines – Metal Clips

1. Take the wider hook arm of the clip (front) and place that against the inside lip of the outer trim of the mat and swing the clip over the top edge of the mat so the slimmer hook (back) is behind the mat.
2. Make the slimmer hook (back) attach to the aluminum frame edge gap, as the Image 01 showed.

ICON and Advanced EV

ICON – ¡20, 140 / Advanced EV – Gen1

Package Include

1 x Golf Cart Mat; 4 x Metal Clips; 1 x User Manual

Installation Guidelines

1. Lay the mat in the golf cart by going around the foot pedals carefully.
2. Positioning and tile the mat. Be patient and work the mat back and forth until it is flat around the pedals.
3. Look under the dashboard to find the edge of the factory flooring and pull the Roykaw mat and the factory flooring slightly away from the frame of the golf cart.
4. As Image 01 showed, Take the short arm of the clip with the hooked edge and place that against the inside lip of the trim. With the long arm facing away from you toward the factory flooring and the short arm pressed against the lip of the trim, pull the factory flooring together with the mat and swing the clip around and slide it under the factory flooring. Press the flooring back down into place once it has been secured to the mat. The two mats will be clipped together.

NOTICE

1. Make sure your golf cart is turned off before installing the golf cart mat.
2. The edge of metal clip is sharp, Please be careful not to scratch your hand.
3. For clipped together perfectly, The metal clip be designed compact and maybe have a little tight. you need force to attach them together.
4. The Image 02 below just shows recommended metal clip locations, Not where it should be attached. The metal clips can place anywhere as your needs.

YAMAHA DRIVE / DRIVE2

• Yamaha Adventurer (2007-2016), G29, YDR & Drive (Gen1)
• Yamaha Drive2 (2017-2022) & UMAX Rally 4×4

Package Include

1 x Golf Cart Mat; 4 x Metal Clips; 1 x User Manual

Installation Guidelines

1. Lay the mat in the golf cart by going around the foot pedals carefully.
2. Positioning and tile the mat. Be patient and work the mat back and forth until it is flat around the pedals.
3. Look under the dashboard to find the edge of the factory flooring and pull the Roykaw mat and the factory flooring slightly away from the frame of the golf cart.
4. As Image 01 showed, Take the short arm of the clip with the hooked edge and place that against the inside lip of the trim. With the long arm facing away from you toward the factory flooring and the short arm pressed against the lip of the trim, pull the factory flooring together with the mat and swing the clip around and slide it under the factory flooring. Press the flooring back down into place once it has been secured to the mat. The two mats will be clipped together.

NOTICE

1. Mhe e sure fuel dip is ture, of be re castlin the str ach your hand.
2. For clipped together perfectly, The metal clip be designed compact and maybe have a little tight. you need force to attach them together.
3. The Image 02 below just shows recommended metal clip locations, Not  where it should be attached. The metal clips can place anywhere as vour needs.

 Environmental Protection & Odorless Golf Cart Mat

About Us
Roykaw is a professional manufacturer and exporter of golf cart parts and accessories more than 10 years. Such as golf cart armrest, shock absorbers, rearview mirrors, lighting equipment, golf cart steering wheel, golf cart leaf spring, brake shoes, suspension frames, chassis related parts and other plastic hardware accessories. We mainly provide ODM or OEM for golf cart manufacturer and aftermarket brand sellers. We can also be customized according to samples/drawings.
If you want to maintain or refit your cart, Please search brand “Roykaw” on Amazon.

Maintenance and Care

1. To maintain the look and longevity of the mat, We recom mend applying neutral or mild soaps when cleaning to avoid stripping the natural oils of the rubber.
2. Avoid to contact with acidic or alkaline liquids, or something corro – sive chemicals.
3. Do not expose to the burning sun for a long time which may acceler – ate the rubber aging.

After Sales and Warranty
Roykaw will provide warranty replacement of golf cart mats that break or tear due to manufacturing or factory defects within one year from the date you receive the item.

1. This warranty guarantees that the mat will not deform, tear or break under normal non-commercial usage.
2. Intentional damage or damage by an outside force such as puncture by golf spikes or chew by pets. Will not qualify for warranty consider – ation.
3. The mat being damaged during installation or altering the mat shape in anyway will void the warranty.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>