RODE MICROPHONES M2-GO Wireless Handheld Condenser Microphone User Guide

: June 13, 2024
: RODE MICROPHONES

Table of Contents

RODE MICROPHONES M2-GO Wireless Handheld Condenser Microphone
Using instruction
Battery
Power
Important Safety Information
FCC
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RODE MICROPHONES M2-GO Wireless Handheld Condenser Microphone

RODE-MICROPHONES-M2-GO-Wireless-Handheld-Condenser-Microphone-
product

REGULATORY AND SAFETY GUIDE

Using instruction

Battery

Power

Important Safety Information

Read and understand the instructions and safety guide completely before using the product.
Ensure both the instruction manual and regulatory and safety guide are accessible to all users, including when passing the product on to third parties.
Only use this product with authorised RØDE accessories.
Do not open the product housing. This will void the warranty.
Refer all service and repairs to RØDEapproved service personnel. Service or repair is required for products that have been damaged, exposed to liquid, rain or moisture, or do not operate normally.
Use the product only in the ways described in the instructions.
Do not use the product if it was damaged during transportation.
Keep the product away from liquids and electrically conductive objects that are not necessary for the operation.
Do not use any solvents or corrosive cleaning agents to clean the product.
Do not adjust the control of the product in an environment that requires your attention (Operating machinery, driving, etc..).
A battery cannot be subjected to high or low extreme temperatures, or low air pressure at high altitudes during use, storage or transportation.
Replacement of a battery with an incorrect type can result in an explosion or the leakage of flammable liquid or gas.
Disposal of a battery into fi re, or a hot oven, mechanically crushing or cutting of a battery, can result in an explosion.
Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas.
A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.

North America

The M2-GO must not be co-located or
operated in conjunction with any other
antenna or transmitter.

FCC

The device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth in an uncontrolled environment.

Changes or modifications not expressly approved by RØDE could void the user’s authority to operate the equipment.

This device contains license-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.

EU Compliance Statement
Hereby, RØDE Microphones declares that the radio equipment type M2-GO is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of Conformity is available at the following internet address: https://rode.com/m2-go

Frequency Range: 2.402 – 2.480 GHz
Maximum Output Power: < 10dBm

For details of EU representatives go to https://en.rode.com/distributors

NCC Compliance Notice

Without permission granted by the NCC, any company, enterprise, or user is not allowed to change frequency, enhance transmitting power or alter original characteristics as well as performance to approved low power radio-frequency devices. The low-power radio-frequency devices shall not influence aircraft security and interfere legal communications; If found, the user shall cease operating immediately until no interference is achieved. The said legal communications means radio communications is operated in compliance with the Telecommunications Management Act. The low-power radio-frequency devices must be susceptible with interference from legal communications or ISM radio wave- radiated devices.

Note of Disposal
WEEE Directive (2012/19/EU)

The crossed-out bin symbol on a product and/or packing indicates that this product should not be discarded with general domestic waste, but must be collected separately at the end of its service life.Please observe the legal regulations on electrical waste segreation and disposal applicable in your country

Europe/UKCA

South Korea