THEREYE ER-WP02 Countertop Water Purifier User Guide

**THEREYE ER-WP02 Countertop Water Purifier User Guide

**

BEFORE FIRST USE

DO NOT use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. For cold water (41°F-95°F) only.

• Locate the water purifier upright on a flat, dry surface away from direct sunlight and grease dirt.
• Flush the system for 3 times before first use, after filter replacement or a long period of non-use.

1. Remove the raw water tank lid and hold to lift the raw water tank.

2. Remove the top cover and filtered water tank lid. Let it stand for 1 hour.
   

3. Fill the raw water tank with fresh tap water below the MAX water line.
   

4. Place the top cover, raw water tank and tank lid back in place.
   

5. Plug in the water purifier and press ON/OFF button to turn it on.
   

6. Wait for about 10min until water full . Place a large container under the nozzle.
   

7. Hold Start/Stop button for 5s until a beep is heard to drain out all filtered water

8. If lights up during draining, discard the retained water and refill the raw water tank.

9. Repeat step 6 and step 7 for 3 times. Then the water purifier is ready for use.

LED DISPALY

DISPENSING WATER

Preconditions:

1. Fill the raw water tank with fresh tap water below MAX water line.

2. Wait until enough filtered water is made (volume or ).

3. Start/Stop

4. Start/Stop

| Water at Room Temperature

1. Press Start/Stop to start dispensing.
2. Press Start/Stop again to stop at desired volume. Blue > Dispensing water at room temp.

Blue Dispensing water at room temp

|

1. Unlock

2. Start/Stop

3. Start/Stop

| Hot Water (98°C/208°F by default)

1. Press Unlock to unlock hot water.
2. Press Start/Stop to start dispensing.
3. Press Start/Stop again to stop at desired volume.

Red > Dispensing hot water

---|---|---|---

1. Unlock

2. Temp +/-

3. Start/Stop

4. Start/Stop

| Water at Selected Temperature

1. Press Unlock to unlock hot water.
2. Press Temp+/- to select temperature.
3. Press Start/Stop to start dispensing.
4. Press Start/Stop again to stop at desired volume.

Red Dispensing water at selected temp.

| |

Empty Filtered Water Tank
Hold Start/Stop button for 5s until a beep is heard to start draining. Vat until all filtered water is drained out or press Start/Stop again manually stop draining.

Green
Draining out filtered water

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>