FOSCAM V5P QHD WiFi IP Camera User Manual
- June 1, 2024
- FOSCAM
Table of Contents
FOSCAM V5P QHD WiFi IP Camera
Specifications
- Spotlight: Yes
- Color Temperature: RGB
- Sensor Type: CMOS
- Image Sensor Display Resolution: QHD
- Min. Illumination: 0 Lux with IR
- Lens: Varifocal Lens
- Lens Type: Fixed
- Angle of View: 110 degrees
- Image Compression: H.264/H.265
- Image Frame Rate: 30fps
- Resolution: 2560×1440
- Video Stream: Dual stream
- Image Adjustment: Brightness, Contrast, Saturation, Sharpness
- Flip Image: Vertical and Horizontal
- Night Mode: Yes, with IR-Cut Filter
- Night Visibility: Up to 30 meters
- Audio: Two-way Audio with Built-in Mic and Speaker
- Audio Compression: AAC/G.711A/G.711U
- Siren: Built-in Siren
- Ethernet: RJ45 10M/100M Ethernet
- Wireless Standard: IEEE 802.11b/g/n
- Network Security: WEP, WPA, WPA2
- Remote Access: Yes, via Foscam App
- Wifi Configuration Mode: One-key WiFi Configuration
- Network Protocol: IP, TCP, UDP, HTTP, HTTPS, SMTP, FTP, DHCP, DDNS, UPnP, RTSP, ONVIF
- System Requirements: iOS, Android
- Motion Detection: Yes
- Vehicle Detection: Yes
- Human Detection: Yes
- User Accounts: Up to 4 Users simultaneously
- Privacy Block: Yes
- WDR: Digital WDR
- Zoom: 4x Digital Zoom
- Storage: Supports Micro SD Card (not included)
Product Usage Instructions
Packing Contents Verification
Please ensure all contents listed in the package are present before proceeding with the installation.
SD Card Management
This camera supports Micro SD Card. Ensure to reboot the cameraafter inserting the SD card for proper functionality.
Foscam App Installation and Device Setup
To add the device, download and install the Foscam App by scanning the provided QR code. Follow the instructions in the Quick Setup Guide for detailed steps.
Installation and Waterproof Lid Installation Guide
To install the camera, point it at the desired location and use the provided screws for mounting. If installing outdoors, it is recommended to follow the Waterproof Lid Installation Guide for added protection against weather elements.
Frequently Asked Questions
Q: Can I access the camera remotely?
A: Yes, you can remotely access the camera using the Foscam App on your mobile device.
Q: What is the night visibility range of the camera?
A: The camera provides night visibility of up to 30 meters.
Q: How many user accounts can be created for this camera?
A: This camera supports up to 4 user accounts that can access the feed simultaneously.
Q: Does the camera support motion detection?
A: Yes, the camera supports motion detection functionality.
Q: What type of storage does the camera support?
A: The camera supports Micro SD Card storage (Micro SD Card not included).
Model: V5P
Overview
Key Features
- 5MP QHD Waterproof IP Camera
- H.264+/H.264 video Compression
- Supports Human detection, Motion Detection and Vehicle Detection
- Compatible with free Foscam Video Management Software
- Compatible with free Foscam iOS and Android APP
- Support 2.4GHz&5GHz dual-band WiFi
- Supports Full Duplex two-way Audio
- Supports WDR(Wide-Dynamic Range)
- Supports 256GB Micro SD Card storage(External)
- Night Vision Range up to 20m(66 feet)
- P2P Feature for Easy Remote Access
- Supports image snapshot
- Supports dual-stream
- Supports remote viewing & record from anywhere anytime
- Multi-level users management with password protection
- Supports multiple network protocols: IP, TCP, UDP, SMTP, FTP, DHCP, RTSP
- Supports Alexa
- Supports Google home
Read before Use
Please first verify that all contents received are complete according to the
Package Contents listed below. Before the Network Camera is installed, please
carefully read and follow the instructions in the Quick Setup Guide to avoid
damage due to faulty assembly and installation. This also ensures the product
is used properly as intended.
Packing Contents
| ● Camera× 1 | ● Ethernet Cable× 1 |
|---|---|
| ● Quick Setup Guide × 1 | ● Expansion Screws× 1 |
| ● Waterproof Lid × 1 | ● Mounting Template× 1 |
| ● Power Adapter × 1 | ● Wi-Fi Antenna× 1 |
Physical Description
- Microphone: Built-in Microphone.
- Lens: Fixed focus lens.
- Spotlight：See full-color images at night with the spotlight on.
- LED Indicator：Infrared LED for night vision.
- Reset: Press and hold on the reset button for 3~5 seconds. Releasing the reset button, the password will back to the factory default administrator password.
- Micro SD Card slot: Supports up to 256GB SD card for storing the video.
- Speaker: Built-in speaker
- Power: AC wiring interface.
- LAN:10/100M adaptive Ethernet interface. Through this interface, IP camera can be connected with various network devices, such as hub, router, etc.
Card Management
This camera supports Micro SD Card.
When you plug in the SD card during the camera work process, please reboot the
camera again, or else the SD card might not work well.
On Foscam app go to the Settings Device Status Device Status page, you can see
the SD card status.
Add Device: Connection via the Foscam App
Scan the QR code below to download and install the Foscam APP.
Please refer to the Quick Setup Guide.
Installation
Please refer to the Quick Setup Guide.
Point the camera at the desired location and use the screws provided to mount
it.
Please Note:
Ensure that rain or water will not reach the connector ports at the end of the
pig tail wiring. These connectors are not weather-resistant.
Waterproof Lid Installation Guide
When mounting your camera outdoors, you are suggested to install a waterproof
lid for it. You may follow the steps for installation.
- Thread the Ethernet cable through the top cover and then the waterproof connector.
- Put the rubber seal ring around the Ethernet cable between the top cover and the waterproof connector.
Note: The rubber seal ring provided has been cut. If not, you may manually cut
it.
- Put on the rubber O-ring to the Ethernet port of the camera and plug the Ethernet cable into the Ethernet port.
- Align the waterproof connector with the Ethernet port, then twist it clockwise to tighten the two parts.
- Push the rubber seal ring into the waterproof connector, then screw the top cover and lock it into position firmly to finish installation.
Default Parameters
Default network parameters
IP address: obtain dynamically Subnet mask: obtain dynamically Gateway: obtain
dynamically
Specification
| ITEMS | V5P |
|---|---|
| Spotlight | Color Temperature |
Image Sensor
| Sensor Type| High Definition Color CMOS Sensor
Display Resolution| 5.0Megapixels(3072*1728)
Min. Illumination| 0 Lux (With IR Illuminator)
Lens| Lens Type| f:4mm; F2.1
Angle of view| Diagonal: 107.9°, Horizontal: 91.6°, Vertical: 49.6°
Video
| Image Compression| H.264+/H.264
Image Frame Rate| Max 25fps (5MP), downward adjustable
Resolution
| 5MP(30721728) 1.5M/25 fps, 1080P(19201080)1M/25fps,
720P(1280*720)1M/15fps
Stream| Dual stream
Image Adjustment| The hue, brightness, contrast, saturation, sharpness are
adjustable
Flip Image| Flip and mirror
Night Mode
| Manual and automatic modes, when the white light is on, the night
vision image is colored
Night Visibility| 20m
Audio
| Input/Output| Built-in mic and speaker, supports full duplex 2-way Audio
Audio Compression| PCM/AAC
Siren| Support maximum 100dB alarm siren
Network
| Ethernet| One 10/100Mbps RJ45 port
Wireless Standard| IEEE802.11b/g/n/ac
Wireless Security| WPA, WPA2
Remote Access| P2P
Wifi configuration Mode| Support scan QR code, sound wave to add camera
Network Protocol| IP, TCP, UDP, SMTP, FTP, RTSP
System Requirements| ****
Operating System
| Microsoft Windows (Foscam VMS), MacOS (Foscam VMS), Android
(Foscam app), iOS (Foscam app)
Other Features
| Light Control| Manual switch or alarm linkage
Motion Detection| Alarm via E-Mail, FTP and Foscam app when an event is
detected
Vehicle Detection| Alarm via E-Mail, FTP and Foscam app when an event is
detected
Human Detection| Alarm via E-Mail, FTP and Foscam app when an event is
detected
User Accounts| Three levels user role
Privacy Block| Yes
WDR| Improve image clarity in complex scenario
Zoom| 6X digital zoom function
Storage
| Support max. 256GB Micro SD card, local and FTP storage, Foscam
cloud storage
| Intelligent Assistant | Works with Alexa, Google Home | |
|---|---|---|
| Power | Power Supply | DC12V/1A |
| Power Consumption | 5Watts (Max.) | |
| Physical | Dimension(LxWxH) | 170(L)x66 (W)x66 (H) |
| Net Weight | 346g |
Environment
| Waterproof| IP66
Operating Temperature| -20°C~ 50°C (-4°F ~ 122°F)
Operating Humidity| 20% ~ 85% non-condensing
Storage Temperature| -20°C ~ 60°C (-4°F ~ 140°F)
Storage Humidity| 0% ~ 90% non-condensing
Certification| CE, FCC, RoHS,WEEE
For other parts, please refer to the “FOSCAM Camera User Manual
Documents / Resources
|
FOSCAM V5P QHD WiFi IP
Camera
[pdf] User Manual
V5P QHD WiFi IP Camera, V5P, QHD WiFi IP Camera, WiFi IP Camera, IP Camera
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>