JJC LLC 2022+ Ford Maverick A-Pillar Ditch Light Brackets Instruction Manual
- June 2, 2024
- JJC LLC
Table of Contents
JJC LLC 2022+ Ford Maverick A-Pillar Ditch Light Brackets
TOOLS
CONTENTS
|
TOOLS
---|---
QTY
|
DESCRIPTION
|
10mm socket or wrench Plastic clip removal/pry tool Painter’s tape
2
|
Light Bracket (One Left & One Right)
2
|
Lock Washer
2
|
PPF Film Strip
-
Passenger side bracket
-
Driver side bracket
-
Lock washer
-
PPP Film
Installation Instructions
Starting on the driver’s side, move the trim piece as identified below. Using
a plastic trim removal tool, you can gently pry the rubber cowl trim away from
the fender. With the trim out of the way, remove the bolt circled below using
a 10mm wrench.
The next step is to install the paint protection film to the backside of the
fender. Oversized pieces are provided in case you wish to cover a larger area
than shown below.
This is also a good time to place painters tape across the top of the fender
to prevent scratching.
Install the light bracket by reusing the original fender bolt. The included
lock washer can be inserted in between the bracket and fender to help prevent
rotation. These brackets are very low profile, thus workspace is tight. You
can pre-install your lights onto the brackets if you find that easier.
Once the driver side bracket is mounted securely, you may repeat this process
to install the passenger side bracket. The final step is to remove the
painter’s tape and reinstall the rubber cowl trim pieces.
Optional: you may notch or trim these trim pieces as shown below, this is
not required.
Congratulations on adding ditch lights to your Maverick!
DISCLAIMER FOR JJC LLC PRODUCTS: Buyer assumes all risk and liability whatsoever for the installation and use of JJC LLC products. JJC LLC assumes no liability for injury, loss, incidental or consequential damages incurred as a result of the use or installation of these products. Professional installation is recommended.