Mr Steam Audio XBK Speaker User Manual

June 2, 2024
Mr.Steam

Mr Steam Audio XBK Speaker

Mr-Steam-XBK-Speaker-product

Specifications

  • Model: AudioX
  • Speaker Ratings:
    • Supply Rating: 100-240 VAC, 50/60 Hz, 1.0 A max

Product Usage Instructions

Installation Instructions:

  1. Cut a 6 9/16 x 6 9/16 (167 mm x 167 mm) hole to mount each speaker.
  2. The maximum distance between each speaker is 15 feet.
  3. Apply a bead of silicone RTV around the edge of the AudioX to obtain a watertight seal.
  4. Fit the AudioX into the speaker-mounting hole.
  5. Secure the AudioX in place using the integral mounting brackets. Do not over tighten screws.
  6. Gently tug on speakers to ensure they are secure in the ceiling.
  7. Replace the AudioX grills by pressing them in place.
  8. Let the silicone cure per manufacturer’s instructions before using steam room.
  9. Connect the secondary AudioX speaker to the other end of the audio cable and repeat steps 4-10.
  10. Do not place AudioX in contact with direct water or steam emission.

Connecting to AudioX:

  1. On your iSteamX, go to the system settings page and select Bluetooth.
  2. Tap pair new device and look for MrSteam.
  3. When prompted, enter the default password: 1234.

FAQ

  • Q: Can I install the speakers closer than 15 feet apart?
    • A: It is recommended to maintain a maximum distance of 15 feet between each speaker for optimal performance.
  • Q: What should I do if the mounting brackets are not engaging correctly?
    • A: Ensure that the mounting brackets are correctly aligned and securely tightened to avoid any falling object hazard.

PACKAGE CONTENTS

  • 1x AudioX [pair of speakers]
  • 1x Installation Instructions
  • 2x Templates
  • 1x power cable
  • 1x audio cable

SPEAKER RATINGS

60 watt peak/25 watt RMS/8 ohm impedance/5” depth Operating Temperature 0 °C – 60 °C (32 °F – 140 °F)

SUPPLY RATING:

100-240 VAC, 50/60 Hz, 1.0 A max.

  1. Cut a 6 9/16” x 6 9/16” (167 mm x 167 mm) hole to mount each speaker.The maximum distance between each speaker is 15 feet.
    Caution
    All audio wiring shall be installed in accordance with National Electric Code and local electrical codes.

  2. Connect power supply and audio cable to the primary AudioX speaker and to wall outlet.

  3. Connect to the speaker and test speakers before securing to ceiling.

  4. Remove the front grill of the AudioX by gently rotating out any two opposite brackets by hand as shown in the installed view and pressing them down to pop the grill off. Return the brackets to the original position before installing AudioX. Failure to engage mounting brackets correctly or improper installation may result in a falling object hazard.

  5. Apply a bead of silicone RTV (not supplied) around the edge of the AudioX as shown in the diagram as required to obtain a watertight seal.

  6. Fit the AudioX into the speaker-mounting hole.

  7. Secure the AudioX in place using the integral mounting brackets.
    The mounting brackets will rotate out and tighten when the 4 large screws are turned clockwise.
    NOTE: DO NOT OVER TIGHTEN SCREWS.

  8. Gently tug on speakers to ensure they are secure in the ceiling.

  9. Carefully replace the AudioX grills by pressing them in place.

  10. Let the silicone cure per manufacturer’s instructions before using steam room.

  11. Connect the secondary AudioX speaker to the other end of the audio cable and repeat steps 4-10.

Connecting to AudioX

  1. On your team, go the system settings page and select bluetooth
  2. Tap pair new device and look for MrSteam
  3. When prompted, enter the default password: 1234

IMPORTANT: Do not place AudioX in contact with direct water or steam emission

WIRING DIAGRAM

Mr-Steam-XBK-Speaker-fig \(4\)Mr-Steam-XBK-Speaker-
fig \(5\) Mr-Steam-XBK-Speaker-fig \(6\)

WARRANTY: To view or download the MrSteam Controls & Accessories Warranty and register your product go to: blog.mrsteam.com/wr

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

ISED Warning

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

  1. This device may not cause interference.
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Products, information and specifications are subject to change without notice. Please call Technical Support at 1.800.76.STEAM (East Coast) or 1.800.72.STEAM (West Coast) for more information. mr.steam® I hello@mrsteam.com I www.mrsteam.com 43-20 34th Street, Long Island City, NY 11101 TEL: 1 800 76 STEAM I 9410 S. La Cienega Blvd. Inglewood CA 90301 TEL: 1 800 72 STEAM 2020 © MrSteam and des., A Lifetime of Pleasure, AirTempo, AromaFlo, AudioWizard, AutoFlush, AutoSteam, Butler Package, ChromaSteam, Clean Steam…Every Time, Club Therapy, CT Day Spa, Digital 1, Express Steam, Feel Good Inc., From Bathroom to Spa, HomeWizard, iButler, iGenie, iSpa Package, iSteam, Tiempo, Tiempo/Plus, Linear Steamhead, Making Wellness a Way of Life, Music Therapy, My Steam, SmartSizing, Spa Package, Steam Genie, Steam on Demand, Steam in a Box, Steam@Home, SteamStart, SteamTherapy, , Tala, Tala Bath & Body, Tempo, The Intelligent Steambath, Valet Package, and Virtual Spa System are registered trademarks of  0581 Rev 3.24

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals