PHXIN T12PRO Motorcycle Bluetooth Intercom User Manual
- June 4, 2024
- PHXIN
Table of Contents
PHXIN T12PRO Motorcycle Bluetooth Intercom
QUICK START GUIDE
INSTALLATION INSTRUCTIONS
First fix the screws on the base, insert the installed base into the left side of the helmet, use the socket head cap screws Tighten the screws with the knife, and install the main unit on the base.
If there are any problems with mounting the bracket, you may use the 3M tape bracket .peel off the protective backing sheet of the 3M tape and adhere the bracket onto the helmet.Pressfor15 seconds and glue dry for 24 hours.
Tear off the rough surface of the left and right speaker Velcro on the
headset, and paste them on the left and right ears of the helmet, then After
attaching the speaker to the Velcro surface in the helmet, the speaker with
short headphone cable is installed in the left ear.
The long horn is mounted on the right ear.
Paste the microphone Velcro on the rough surface of the helmet, and then paste
the microphone on the on the Velcro.
Product Failure Description
(Please be sure to fill in your related information so that we can better serve you Intime)
FCC
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-
* Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>