PHXIN T60R Motorcycle Bluetooth Intercom User Manual

June 3, 2024
PHXIN

PHXIN T60R Motorcycle Bluetooth Intercom User Manual
PHXIN T60R Motorcycle Bluetooth Intercom

QUICK START GUIDE

  • A. Volume-
  • B. Volume+
  • C. Power button
  • D.Button Icon  Earphone port(charing)
  • E.Button Icon Mesh Intercom button

INSTALLATION INSTRUCTIONS

First fix the screws on the base, insert the installed base into the left side of the helmet, use the socket head cap screws Tighten the screws with the knife, and install the main unit on the base.
Installation Instructions

If there are any problems with mounting tne bracket, you may use nthe 3M tape bracket.peel off the protective backing sheet of the 3M tape and adhere the bracket onto the helmet. Press for 15 seconds and glue dry for 24 hours.
Installation Instructions

Tear off the rough surface of the left and right speaker Velcro on the headset, and paste them on the left and right ears of the helmet, then After attaching the speaker to the Velcro surface in the helmet, the speaker with short headphone cable is installed in the left ear.
The long horn is mounted on the right ear.
Paste the microphone Velcro on the rough surface of the helmet, and then paste the microphone on the on the Velcro.

TYPE

| OPERATION| BUTTON|

COMMANDS

---|---|---|---
Basic Operation| Power On|

+Button Icon

| press for one second
Power Off|

+Button Icon

| press for one second
Volume Up| | press for one second
Volume Down| | press for one second
Check the battery|
| press for 8 second
Mobile Photo| Moblie Phone pairing| | quick press twice
 | Voice Command (Siri/S-Voice)|
| short press once
 | Answer the call| | short press once
 | End phone call|
| quick press twice
 | Reject phone call| | quick press twice
 | Answer third party call|
| quick press twice
 | Reject third party call| | quick press twice
 | Moblle Phone Pairing| | press for 5 seconds
Pairing With Phone| When the “T60R ”is power off ,hold down the “center key” for 5 seconds.after “T60R”the paring state,the red and blue lights flashing alternately . turn on the bluetooth of the mobile phone ,search for new devices,and select the connection when “T60R”is found.
MESH Intercom| Mesh interphone enabled|  | short press once
Mesh interphone closed|  | short press once
Volume Up| | short press once
Volume Down|
| short press once
Reset the MESH Intercom|  | press for 8 seconds
While Mesh intercom mode on ,“T60R”will autom atically connect to nearby “T60R” users and allow them to support up to 32 rider onlino at the same time through open intercom free conversation. When the headset Mesh is reset,it clears all network ing informationand automatically returns to the default channel 4.
Setting Frequency Range| Enter channel setting| Button
Icon| press for 2 second
surfing the channels| Button Icon| quick press twice
Save channel and exit|

Button Icon

| press for 2 second
If another team is using channel 4(the default channel)and the network intercom is being interfered with,it can be changed to another channels 1 to 10
            Bluetooth Intercom| Intercom No1 and No 2 enter into pairing mode|

+

| press for 2 second
Short press one of the intercom is “power”key to search| | short press once
Bluetooth Intercom|
| press for 2 second
hang up the Bluetooth intercom| ****| short press once
FM Radio| FM Radio on|

+

| press for 2 second
FM Radio off|

+

| press for 2 second
Scan up| ****| quick press twice
Scan down|


| quick press twice
Universal Bluetooth Intercom| Intercom No1 and No 2 enter into pairing mode|


| press for 2 second
Short press one of the intercom is “power”key to search|

+

| short press once
Bluetooth Intercom|

+

| short press once
hang up the Bluetooth intercom|

+

| short press once
 | Music play| | short press once
Music pause|
| short press once
Last song|


| quick press twice
Next song| | quick press twice
share the music that is playing|
| quick press twice
Restore factory setting| power off, clear set|

+Button Icon

| press for 5 seconds

Warranty Card

FCC Statement

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

QR Code:
QR Code

PHXIN Logo

Documents / Resources

| PHXIN T60R Motorcycle Bluetooth Intercom [pdf] User Manual
T60R, 2AQN2-T60R, 2AQN2T60R, T60R Motorcycle Bluetooth Intercom, Motorcycle Bluetooth Intercom, Bluetooth Intercom, Intercom
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals