GELE 1NLY Single Handle High Arc Brushed Nickel Pull Out Kitchen Faucet Installation Guide
- June 2, 2024
- GELE
Table of Contents
**GELE 1NLY Single Handle High Arc Brushed Nickel Pull Out Kitchen Faucet Installation Guide
**
Applicable faucets (including but not limited)
TOOLS YOU WILL NEED
-
Adjustable wrench
-
Phillips screwdriver
-
Hex Wrench
-
Two Male Supply
-
Pipe tape
-
Silicone sealant/Putty
INSTALLATION
Prior to installation: Shut off water supply. Remove old faucet.
Clean sink/counter top surface in preparation for new faucet.
-
Apply some plumbers putty or other suitable sealant to the bottom edge of undercover.
-
Allign and press into place.
-
Insert the faucet through sink
-
Screw the nut onto shrank, leaving approximately 0.12″ (3mm)betweenthe ring and the sink.
-
Tighten fitting nuts with adjustable wrench. Do not over tighten!
-
Remove excessive putty, adjust slightly Connect and tighten the supply hoses. the position of faucet.
-
Connect and tighten the supply hoses.
-
Check for leaks.
-
Care and Cleaning
For best results, keep the caring for your product:- Use a mild detergent such as liquid soap E dishwashing and warm water for cleaning. Do not use abrasive cleaners that may scratch or dull the surface.
- Carefully read the cleaner product label to ensure the cleaner is safe for use on the material.
- Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
- Do not allow cleaners to sit or soak on the surface.
- Wipe surfaces clean and rinse completely with water immediately after cleaner application. Rinse and dry any over spray that lands on nearby surfaces.
Right of product modification such as dimension without notice is reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>