stratasys DOC-60019 Origin One Tray Pour Jig User Guide

: June 2, 2024
: stratasys

Table of Contents

ASSEMBLY INSTRUCTION
Operation
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

stratasys DOC-60019 Origin One Tray Pour Jig User Guide

ASSEMBLY INSTRUCTION

The Origin One Tray Pour Jig is designed to assist in cleaning the tray by allowing resin to be poured cleanly and efficiently into a material bottle. The Tray Pour Jig uses locating bumpers and a magnetic locking switch to hold the tray in place. A filter holder is designed to hold the 190um filter in place above the material bottle. Friction hinges make pouring the tray as easy as possible while preventing the tray from rotating backwards during operation.

Assembly

Remove the Origin One tray pour jig handle, base, and filter holder from the shipping packaging.
Remove all wrapping material from the Origin One tray pour jig handle, base, and filter holder.
Attach the Origin One tray pour jig handle to the base using the two provided M6 hex screws and 5mm hex key. Tighten the hex screws until they are snug. See Figure 1.
Figure 1: Attach handle to base
Attach the filter holder to the base by sliding the filter holder tabs into the slots in the tray pour jig base.
Confirm the filter holder opening faces forward. See Figure 2
Figure 2: Attach filter holder to base

Operation

Place a filter into the filter holder.
Hook the two filter tabs onto the two filter holder posts as shown below. See Figure 3
Figure 3: Filter placement
Place the Origin One tray containing resin onto the Origin One tray pour jig platform. Confirm the corner of the tray aligns with the platform alignment tab as shown below. See Figure 4.
Figure 4: Align the tray
Attach the tray pour spout to the tray.
Place a resin receptacle under the resin filter.
Unlock the platform locking tab. This secures the tray to the platform and allows the platform to be raised. See Figure 5 (page 6) and Figure 6 (page 6).
Figure 5: Platform locked

Figure 6: Platform unlocked
Using the handle, slowly raise the tray to empty the resin from the tray, through the filter, and into the resin receptacle. See Figure 7 (page 7).
Figure 7: Pour resin
When the resin has finished puring into the receptacle, lower the handle.
Lock the platform locking tab. This will secure the platform and allow the tray to be removed.
Clean any remaining resin from the tray in accordance with manufacturers recommendations.

Swww.stratasys.com
c-support@stratasys.com
© Copyright 2023 Stratasys. All rights reserved.
DOC-60019 Rev. A

Customer acknowledges the contents of this document and that Stratasys parts, materials, and supplies are subject
to its standard terms and conditions, available on http://www.stratasys.com/legal/terms-and- conditions-of-sale, which
are incorporated herein by reference.

The specifications and/or information on which this document is based are subject to change without notice.

Stratasys and Origin One are trademarks of Stratasys and/or subsidiaries or affiliates and may be registered in certain jurisdictions. All other product names and trademarks are the property of their respective owners.