SVD PET Comfy Plus Cat Hammock Wall Mounted with Cat Toy Installation Guide
- June 2, 2024
- SVD PET
Table of Contents
SVD PET Comfy Plus Cat Hammock Wall Mounted with Cat Toy
DESCRIPTION
- Rod cap (x2)
- Front rod (has the SVD.PET logo)
- Support arm with wall mount (x2)
- Fabric bed
- Cat toy
- Rod cap screw (x4)
- Toggle bolt for drywall (x4)
- Screw and anchor for cement or masonry wall (x4)
Scan the QR Code to access the installation guide online. SVD.PET is a
registered trademark of Silicon Valley Devices LLC.
@2023 Silicon Valley Devices LLC.
Palo Alto CA 94306
www.SVD.PET
Contact us : [email protected]
TOOLS NEED
Assemble Hammock
- Position the front rod so the SVD logo is on the front and faces up. Attach a rod cap to each end of the rod. The holes for the screws should be on the bottom. Insert the screws and tighten them.
- Position the fabric bed with the smooth side facing up. Insert the two support arms (with the wall mount already attached) into the fabric bed.
- Attach the front rod. Insert the screws and tighten them.
Install Hammock to Wall
-
Tape the paper installation template (included in the package) at the desired location and height, then drill the holes as outlined on the template. Read the instructions on the template before drilling holes.
For the strongest weight-bearing support: Place one end of the hammock on your wall where there is a stud. Once you locate the stud, screw and secure the hammock wall mount screws (#8).
Pre-drilling a hole in the drywall is NOT necessary when securing a stud. -
A. Install on drywall (not on a stud): Insert the toggle bolt on the hammock wall mount. Put the spring wing on the toggle bolt. Insert the spring wing into the drilled holes. Tighten the toggle bolt with the Allen key in the package. Finally, insert the toy into the hammock.
-
B. Install on cement or masonry wall: Insert anchors into the drilled holes. Align the holes of the hammock wall mount to the anchors in the wall, insert then tighten the screws. Finally, insert the toy into the hammock.
