CHAUVET PROFESSIONAL MAVERICKSTORM1HYBRID LED Moving Head Spot User Guide
- May 15, 2024
- Chauvet Professional
Table of Contents
CHAUVET PROFESSIONAL MAVERICKSTORM1HYBRID LED Moving Head Spot
Scan the QR code to access the product page, warranty terms, and the complete
User Manual
Safety Notes
These Safety Notes include important information about the installation, use, and maintenance of the Maverick Storm 1 Hybrid.
- The luminaire is intended for professional use only.
- The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 32.81 ft (10 m) is not expected.
- If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord exclusively available from the manufacturer or its service agent.
- The light source contained in this luminaire shall only be replaced by the manufacturer its service agent or a similar qualified person.
CAUTION:
- This product’s housing may be hot when operating. Mount this product in a location with adequate ventilation, at least 20 in (50 cm) from adjacent surfaces.
- When transferring the product from extreme temperature environments, (e.g., a cold truck to a warm humid ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure, allow the product to fully acclimate to the surrounding environment before connecting it to power. Flashing light is known to trigger epileptic seizures. Users must comply with local laws regarding notification of strobe use.
ALWAYS:
- Disconnect from power before cleaning the product or replacing the fuse.
- When using an IP65-rated product in an outdoor environment, use IP65- (or higher) rated power and data cable.
- Replace and secure IP-rated protective covers to all power, data, USB, or other ports when not in use.
- Replace the fuse with the same type and rating.
- Use a safety cable when mounting this product overhead.
- Connect this product to a grounded and protected circuit.
DO NOT:
- Open this product. It contains no user-serviceable parts.
- Look at the light source when the product is on.
- Leave any flammable material within 20 cm of this product while operating or connected to power.
- Connect this product to a dimmer or rheostat.
- Operate this product if the housing, lenses, or cables appear damaged.
- Submerge this product (adhere to standards for the published IP rating). Regular outdoor operation is fine.
- Permanently install outdoors in locations with extreme environmental conditions. This includes, but is not limited to:
- Exposure to a marine/saline environment (within 3 miles of a saltwater body of water).
- Locations where normal temperatures exceed the temperature ranges in this manual.
- Locations that are prone to flooding or being buried in snow.
- Other areas where the product will be subject to extreme radiation or caustic substances.
- ONLY use the handles or the hanging/mounting brackets to carry this product.
- The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
- The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
- The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.
- To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the product from power via a breaker or by unplugging it.
- In the event of a serious operating problem, stop using it immediately.
FCC Compliance
This device complies with Part 15 Part B of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF Exposure Warning for North America and Australia
Warning! This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and the user. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
What is Included
- Maverick Storm 1 Hybrid
- Seetronic Powerkon IP65 power cable
- 2 omega brackets with mounting hardware
- Quick Reference Guide
AC Power
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
AC Plug
Connection| Wire (U.S.)| Wire (Europe)| Screw
Color
---|---|---|---
AC Live| Black| Brown| Yellow/Brass
AC Neutral| White| Blue| Silver
AC Ground| Green/Yellow| Green/Yellow| Green
To eliminate unnecessary wear and improve its lifespan, during periods of non- use completely disconnect the product from power via a breaker or by unplugging it.
Mounting
Before mounting this product, read the Safety Notes. Use at least 2 mounting points per product. Make sure the mounting clamps are capable of supporting the weight of the product. For the Chauvet line of mounting clamps, go to
http://trusst.com/productcategory/truss-clamps.
Mounting Diagram
Control Panel Description
Contact Us
General Information/Technical Support
Chauvet World Headquarters
- Address: 3360 Davie Rd.
- Voice: (844) 393-7575
- Davie, FL 33314
- Fax: (954) 756-8015
- Voice: (954) 577-4455
- Fax: (954) 929-5560
- Toll Free: (800) 762-1084
- Website: www.chauvetprofessional.com
Chauvet U.K.
- Address: Pod 1 EVO Park
- Email: UKtech@chauvetlighting.eu
- Little Oak Drive, Sherwood Park
- Nottinghamshire, NG15 0EB
- Website: www.chauvetprofessional.eu
- UK
- Voice: +44 (0) 1773 511115
- Fax: +44 (0) 1773 511110
Chauvet Benelux
- Address: Stokstraat 18 9770 Kruishoutem Belgium
- Email: BNLtech@chauvetlighting.eu
- Voice: +32 9 388 93 97
- Website: www.chauvetprofessional.eu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>