WILSON 311229 Drive OTR Antenna Installation Guide
- June 4, 2024
- Wilson
Table of Contents
Drive OTR Antenna Installation Guide
Model: 311229
Package Contents
Select Mounting Location & Assemble the Antenna
Once you have determined the best location for the antenna, insert cable through the mast(s) and then through Side Exit Adapter.
Use the thread locker (provided) to thread points and screw them into place.
NOTE: Be sure the antenna is at the correct height before applying the
thread locker.
NOTE: When adding the side exit adapter holds the antenna vertically and
screw the adapter from the bottom up. This reduces cable twisting.
Mounting the Antenna
lf the vehicle does not have built-in Mast Extension mounting points, a three-
way mount is included that will work on vehicles with mirror rails.
NOTE: The cable is strong enough that it may be shut in most vehicle
doors without damaging the cable.
Mounting the Antenna with Spring
If installing with the Spring, disassemble the 3-Way Mount and use the disc washer and nut (provided) to mount the antenna with Spring as shown.
Safety Guidelines & Specifications
RF Safety Warning: Any antenna used with this device must be located at least 8 inches from all persons. AWS Warning: The Outside Antenna must be installed no higher than 32 feet 9 inches (10 meters) above ground.
Electrical Specifications
Frequency Band (MHz)| 698-806| 806-960| 1710-1880| 1850-1990| 1910-2170|
2300-2700
Peak Gain (dBi)| 2.4| 2.6| 3.8| 3.8| 3.7| 4.3
Gain (dBi), Typical @ 2° Elevation| 1.4| 2.4| 3.1| 2.7| 2.4| 2.6
Cable loss LMR-195 30 in.| 1.8| 1.9| 2.8| 2.9| 3.0| 3.3
VSWR| <2:1| <2:1
Efficiency (%)| >70| >65
Polarization| Vertical
Half-Power Azimuth Beamwidth (0)| 360| 360| 360| 360| 360| 360
Half-Power Elevation Beamwidth (0)| 70| 78| 60| 70| 80| 33
Impedance (Ω)| 50
Maximum Power (W)| 10
Mechanical Specifications
Model | 311229, .. |
---|---|
Connector | SMA(F) |
Dimensions (in / mm) | 7.422 X 2.688 / 188 X 68 |
Weight (lb / kg) | JS/ .340 |
Rated Wind Velocity (mph/kph) | 311 / 500 |
Radiator Material | Aluminum |
Radome Material | Alumni Plas~c Type: ASA (Acrylonitrile Styrene) Acrylate) |
2 YEAR WARRANTY
Antennas may also be returned directly to the manufacturer at the consumer’s
expense, with a dated proof of purchase and a Returned Material Authorization
(RMA) number supplied by Wilson Electronics. Wilson Electronics shall, at its
option, either repair or replace the product. Wilson Electronics will pay for
the delivery of the repaired or replaced product back to the original consumer
if located within the continental U.S. Replacement products may include
refurbished Wilson Electronics products that have been recertified to conform
with product specifications.
This warranty does not apply to any antennas determined by Wilson Electronics
to have been subjected to misuse, abuse, neglect, or mishandling that alters
or damages physical or electronic properties. RMA numbers may be obtained by
contacting Technical Support at
866-294-1660.
DISCLAIMER: The information provided by Wilson Electronics, LLC is
believed to be complete and accurate. However, no responsibility is assumed by
Wilson Electronics, LLC for any business or personal losses arising from its
use, or for any infringements of patents or other rights of third parties that
may result from its use.
MARKETING APPROVAL: Installer and end customer hereby grant to Wilson
Electronics the express right to use the installer or end customer’s company
logo in marketing, sales, financial, and public relations materials and other
communications solely to identify the Customer as a Wilson Electronics
customer.
3301 East Deseret Drive, St. George, UT
866.294.1660
www.wilsonelectronics.com
support@wilsonelectronics.com
Copyright © 2020 Wilson Electronics. All rights reserved. Wilson Electronics
products covered by U.S. patent(s) and pending
application(s) For patents go to:
weboost.com/us/patents
NOT AFFILIATED WITH WILSON ANTENNA
GDE000299_Rev02_02.24.21
Drive OTR Antenna
SKU: 311229
MAP: $99.99
FEATURES
- Covers 700, 800, 1700, 1900, 2200 MHz cellular
- All modes, voice and data
- High gain signal output
- The antenna can be configured into multiple lengths from 7.5-40 in.
- Off-road rated to MIL-STD 810H for shock and vibration
- Works with standard CB antenna mounts, includes3-way mirror rail mount
- Connects to mobile cellular boosters
- IP66 rated for outdoor use
- Assembled in the USA
- 2 year warranty
Kit Includes
WARNING: This product can expose you to chemicals including Nickel, which is known to the State of California to cause cancer, and Bisphenol A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Specifications
ELECTRICAL
Frequency Band (MHz)| 698-806| 806-960| 1710-1880| 1850-1990| 1910-2170|
2300-2700
Peak Gain (dBi)| 2.4| 2.6| 3.8| 3.8| 3.7| 4.3
Gain (dBi), Typical @ 2° Elevation| 1.4| 2.4| 3.1| 2.7| 2.4| 2.6
Cable loss LMR-195 30 in.| 1.8| 1.9| 2.8| 2.9| 3.0| 3.3
Efficiency (%)| >70 %| >65%
VSWR| <2:1| <2:1
Polarization| Vertical
Half-Power Azimuth Beamwidth (0)| 360| 360| 360| 360| 360| 360
Half-Power Elevation Beamwidth (0)| 70| 78| 60| 70| 80| 33
Impedance (Ω)| 50
Maximum Power (W)| 10
MECHANICAL
Model | 311230 |
---|---|
Connector | SMA Male / SMB Plug |
Feed Cable Length (in / mm) | 30 / 762 |
Dimensions (in / mm) | 7.422×2.688 / 188×68 |
Packaged Dimensions (in / mm | 8.28×20.27×3.93 / 210x515x100 |
Packaged Weight (lb / kg) | 3.61 / 1.6 |
Wind Loading Area (ft2/m2) | .246 ft^2 / .0229m^2 |
Rated Wind Velocity (mph/kph) | 311 mph / 500km/h |
Radiator Material | Aluminum |
Radome Material | Alumni Plastic Type: ASA (Acrylonitrile Styrene Acrylate) |
Radiation Patterns, 700-900 MHz
Radiation Patterns, 1700-2100 MHz
Radiation Patterns, 2300-2700 MHz
Note: Gain values at 2° elevation indicated are without cable loss. Please refer to the electrical specs chart to include cable losses.
Peak Gain (@ 2° Elevation)
Efficiency (%)
Note:
Gain values at 2° elevation indicated are without cable loss. Please refer to
the electrical specs chart to include cable losses.
Package Dimensions
FOR PARTNER’S USE
Support
2 Year Warranty
Email: support@wilsonelectronics.com
Website: http://support.weboost.com
Phone: +1 866 294 1660 Monday to Saturday
WARNING: Cancer and Reproductive Harm –
www.P65Warnings.ca.gov.
ASSEMBLED IN THE USA
•••
Need help?
Contact us directly.
support.weboost.com 866.294.1660
SIGNAL BARS CAN BE INACCURATE
Signal boost is best measured in how much better you can communicate than
before’
To learn more please visit:
weboost.com/signalbars
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>