Lestar F-HX25-B Glass Display Storage Cabinet Instruction Manual
- May 15, 2024
- LESTAR
Table of Contents
DOUBLE DOOR
“ TRANSPARENT ” CABINET
TEMPERED GLASS
WINE CABINET / DISPLAY CABINET
F-HX25-B
F-HX25-B Glass Display Storage Cabinet
GOOD TO KNOW ABOUT TEMPERED GLASS
IMPORTANT:
HANDLE WITH CARE! A DAMAGED EDGE OR SCRATCHED SURFACE CAN IN EXCEPTIONAL
CASES CAUSE THE GLASS TO CRACK SUDDENLY. HOWEVER, NEVER INTO SHARP FRAG-
MENTS, ONLY INTO SMALL PIECES. AVOID COLLISIONS FROM THE SIDE – THIS IS THE
MOST FRAGILE PART OF THE GLASS.
FURNITURE TIPPING-OVER COULD RESULT IN INJURY OR DEATH TO THE INSTALLER.
ALWAYS SECURE THIS PRODUCT PERMANENTLY TO THE WALL.
The only wall mount included in the package is suitable for wooden walls or
other solid walis.
For wooden wails, please only use the screws, the included plastic screw
accessory is only an option. For hard walls, please drill holes with a hammer
and then insert the screws and plastic accessories. The included wall mount is
not suitable for walls with weak holding force, such as plasterboard. To
attach this product to the plasterboard, please make sure the screws are
securely fastened to the keel. Please choose the proper safety devices
according to the type of wall in your house.
- Tempered glass has a 0.3% risk of self-explosion. In case of such an accident, please contact us and we will replace the damaged glass. During installation, please wear gloves, long-sleeved shirts, pants and socks to avoid possible injury.
- To avoid possible accidents, please keep children away during installation. Please make sure that the installa- tion is done by two adults.
- During installation, use cardboard or carpet as a buffer layer to prevent the glass corner from colliding with hard objects such as the floor. Especially when installing tempered glass, make sure the corners do not hit the floor to prevent the tempered glass from exploding due to force changes.
- When installing a display case, install the anti-tilt device first to avoid possible serious or fatal injury. To pre- vent possible tipping over, the display case must be permanently attached to the wall. Wall mounting is not lim- ited to the fixtures we offer. You are free to install similar fixtures to avoid possible hazards.
- DO NOT operate the cabinet door frequently, and DO NOT shake the cabinet to avoid the risk of colliding with the cabinet door or dropping objects. Again, install an anti-tipping device and keep children away (at least 2 meters /6.6 feet away)from this display case. Please also install a door lock to avoid possible injury from acci- dental operation by children.
- The top/bottom panel of this cabinet is made of MFC/PVC-covered particle board, which is not fireproof.
- For disposal, please contact the relevant local authorities or qualified companies.
- The product is a partially transparent tempered glass display case, it is not fully transparent. After installation, the distance may be different due to the different fixing forces.
- No part of this product can be swallowed, played with, or used for other purposes.
- Please adjust the footrest on the product after installation. The maximum load of the glass plate is 8.00 kg/17.64 tbs. Note that the load capacity is for stored items only.
- Product dimensions may have a tolerance of 10 mm/0.4 inch due to different measuring tools or methods.
- After installing the cabinet, check and tighten all screws to avoid potential safety hazards, such as shelves falling and cabinet structures becoming loose due to loase screws.
Manual preservation/maintenance
Please keep the installation manual properly and do not discard it; Please do
not use acidic or alkaline detergents to clean tempered glass or cover plates.
Do not use a damp cloth to wipe tempered glass. Use a slightly damp cloth
containing water to wipe tempered glass; Please use a dry cloth to wipe the
cover plate! Cabinet movement instructions
Before moving the cabinet, please ensure that there are no objects placed
onthe shelves; remove the tempered glass shelves and place them in a safe
position; check the door lock and ensure that the tempered glass door is
closed; it is forbidden to move objects inside the cabinet; please operate
with four people when moving! Please use gloves during installation When
installing, please start from one side Please make sure to install two
anti fall devices
PRODUCT COMPONENT LIST
| NO | ASSEMBLY | SIZE | NUMBER | TEXTURE OFMATERIAL |
|---|---|---|---|---|
| 1 | Back glass | 1820*390mm(84mm) | 2 | Tempered glass |
| 2 | Side glass | 1820*345mm(S4mm) | 2 | |
| 3 | Door glass | 1799*387mm(65mm) | 2 | |
| 4 | Shelf glass | 775*315mm(S5mm) | 4 | |
| 5 | Top plate | 805*365mm(625mm) | 1 | MFC/PVC edge banding |
| 6 | bottom plate | 805*365mm(S25mm) | 1 | MFC/PVC edge banding |
| 7 | Accessory Package | Various specifications | Various materials |
Product dimensions may have an error with 10mm due to the usage of different
measuring tools or methods.
ASSEMBLY PARTS LIST
| 
---|---
| 
| 
| 
| 
| 
| 
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>