PLEXGEAR MK108 Mouse and Keyboard Combo Instruction Manual
- May 15, 2024
- plexgear
Table of Contents
PLEXGEAR MK108 Mouse and Keyboard Combo
Specifications
- Keyboard:
- Type: Full-size with numpad
- Layout: Nordic QWERTY
- Switches: Rubber membrane
- Size: 44lxl25x68 mm
- Weight: 450 g (without battery)
- Batteries: 2x AAA (not incl.)
- Mouse:
- Sensor: Optical
- Resolution: 800/1200/1600 dpi
- Batteries: lx AA battery ( not incl.)
- Wireless connection:
- Nano receiver: USB-A, 2.4 GHz
- Wireless frequency: 2408-2474 MHz
- Effective radiated power: <20 mW
- In the box:
Wireless keyboard, wireless optical mouse, USB receiver, manual
Use
USB-A receiver and batteries
- Open the mouse’s battery compartment located under the mouse, remove the USB-A receiver and connect it to the computer. Avoid using a USB hub. The receiver’s drivers are installed automatically.
- Insert lx AA battery into the mouse’s battery compartment. Insert 2x AAA batteries to the keyboard’s battery compartment. Mind the polarity.
Note! Remove the batteries from the keyboard before transporting it.
Power on/ off
- Turn the mouse on and off using the On/off switch on the bottom of the mouse. The keyboard turns on automatically when you press a key. The keyboard and mouse automatically enter standby mode after 5 minutes of inactivity. Press any key on the keyboard or button on the mouse to wake them up.
- If the pairing fails or if the mouse and keyboard are disconnected, they have to be paired with the USB receiver again.
Manual pairing method (mouse)
- Disconnect the USB receiver from your computer. Turn the mouse off and on using the On/off switch on the bottom of the mouse. Keep the mouse within 1 meter from the receiver during pairing.
- Connect the USB receiver to your computer. Press and hold the scroll wheel button and the right mouse button for 3 seconds. The LED indicator on the mouse lights up red, and the pairing is completed automatically.
Manual pairing method (keyboard)
- Disconnect the USB receiver from your computer. Make sure the keyboard is powered on. Keep the keyboard within 1 meter from the receiver during pairing.
- Connect the USB receiver to your computer. Press and hold the keys “Esc” and “K” at the same time on the keyboard for 3 seconds, the LED indicator flashes red, and the pairing is completed automatically.
LED indicators
The battery indicator (3) flashes during the pairing process and if the
battery status is low.
- Num Lock
- Caps Lock
- Battery indicator
Simplified EU Declaration of Conformity
Kjell & Company hereby declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU.
Full text of the EU declaration of conformity is available at
www.kjell.com/61231
ABOUT COMPANY
- www.plexgear.com
- Box 50435 Malmo
- Sweden
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>