Rowan Engineering S200 Single Shot Loader User Manual

: May 15, 2024
: Rowan Engineering

Table of Contents

S200 Single Shot Loader
Specifications:
Product Usage Instructions:
FAQ:
Q: Can the loader be used with other rifle models?
Q: How do I switch the loader from right side fitting to left

S200 Single Shot Loader

Specifications:

Product: Single Shot Loader
Calibers: .177 and .22
Compatible with: Air Arms S200 rifle

Product Usage Instructions:

```
1.  **Safety Precautions:**
```

Safety is paramount. Always follow the manufacturer’s safety
instructions when handling the rifle.

```
1.  **Installation:**
```

1. Ensure the rifle is not loaded with pellets.

2. Read and understand the instructions fully before fitting the
loader.

3. The loader can be fitted from either the left or right side
of the rifle. Remove the eccentric washer for installation.

4. Adjust the grub screw on the top of the loader arm to control
the grip of the pellet. Screw inwards to increase grip.

```
1.  **Operation:**
```

1. Open and close the loader using the small lever located on
the side of the loader arm.

```
1.  **Additional Security:**
```

1. The loader comes with an eccentric locking washer and bolt
for extra security. Remove these during installation and refit if
needed after installation.

```
1.  **Ready for Use:**
```

Once fitted, the loader is ready for use.

FAQ:

Q: Can the loader be used with other rifle models?

A: The Single Shot Loader is specifically designed for use with
the Air Arms S200 rifle and may not be compatible with other
models.

Q: How do I switch the loader from right side fitting to left

side fitting?

A: To switch from right side fitting to left side fitting,
remove the loader, swap to the other face, and reinstall following
the provided instructions.

Single Shot Loader .177 and .22 cal. Air Arms S200
Thank you for your purchase. Please read these fitting instructions before using the loader. Your kit should contain 1 off SSL 1 off 1.5mm short allen key 1 off 2.5 mm allen key 1 off eccentric washer and bolt
Safety first. Observe safe practices when handling your rifle and follow the manufacturer’s safety instructions when doing so.
Take extra care when working on your rifle. Ensure that the rifle is absolutely not loaded with pellets.
1. Before fitting the loader, please read and understand these instructions fully.

The loader can set to enable it to be fitted from either the left or right side of the rifle depending on your preference. Remove the eccentric washer to install
2. A M3 grub screw located in the side wall of the loader. This can be optionally very gently tightened to prevent the loader from moving. Don’t forget to loosen this when removing the loader from the rifle. Access the grub screw from the central slot in the loader body. The arrowed position is for left side fitting. Swap the grub screw in to the threaded hole on the other side of the loader for right fitting. This ensures that the loader is pressed against the breach and minimises any gap for the pellet to pass over.

www.rowanengineering.com

3. The grub screw fitted to the top of the loader arm allows the oring which grips the pellet to be adjusted for grip. Screw inwards to swell the oring and provide more grip.
4. Open and close is by using the small lever on the side of the loader arm
5. The loader is also supplied with an eccentric locking washer and bolt. Remove this to install the loader. This can then be refitted to the front face of the loader when installed in the rifle. This is for additional security if required.

6. Once fitted, the loader is ready for use.

Photo shows when loader is fitted from the Right side. Swap to other face for Left side fitting.

www.rowanengineering.com