Rowan Engineering Falcon X50 Adjustable Turret Cap User Guide
- May 15, 2024
- Rowan Engineering
Table of Contents
Rowan Engineering Falcon X50 Adjustable Turret Cap
Product Information
Specifications:
- Inner turret
- Brass Sleeve
- M4x12 cap bolt
- Outer cap
- 1.5mm allen key
- 2.0mm allen key
- 3.0mm allen key
Product Usage Instructions
Safety Precautions:
When handling your rifle and working on the turret cap, always observe safe
practices and follow the manufacturer’s safety instructions to prevent
accidents or injuries.
Fitting Instructions:
- Loosen the central Torx screw and remove the original turret cap.
- Before removing the original cap, ensure the turret is in the center of its travel (approximately 2 turns from the end).
- Attach the brass bush to the turret spigot using the M4x12 bolt, aligning the slot with the turret flats.
- Place the outer cap over the inner turret and gently tighten the 3 M4 grubscrews.
- For zero adjustments, loosen the grubscrews, set zero, and then tighten them back in position.
- Fit the inner turret over the brass sleeve and gently tighten the 3 grub screws.
FAQ:
-
Q: What should I do if I need to make a small adjustment to zero on my scope?
A: Simply loosen the 3 M4 grubscrews, make your zero adjustment, and then tighten them back into position. -
Q: Is it necessary to use all three different sizes of fallen keys provided in the kit?
A: Yes, each allen key size is specifically designed for different components of the turret cap assembly, so it is important to use the correct size for each step of the fitting process.
Thank you for your purchase. Please read these fitting instructions before attempting to fit the Turret.
WHAT’S INCLUDE
Your kit should contain:
- 1 x Inner turret, Brass Sleeve, M4x12 cap bolt.
- 1 x Outer cap.
- 1 x 1.5mm allen key.
- 1 x 2.0mm allen key.
- 1 x 3.0mm allen key.
Safety first
Observe safe practices when handling your rifle and follow the manufacturer’s safety instructions when doing so. Working on any air rifle can be dangerous. Seek advice where and when necessary.
Fitting
- Loosen the central Torx screw and lift off the original turret.
- Before removing the original turret cap, turn the turret so it is in the centre of its travel. ( Normally 2 turns from the end of travel.
- Fit the brass bush to the top of the turret spigot with M4 x12 bolt and lightly tighten ensuring the slot aligns and engages with the turret flats.
- Fit the inner turret over the brass sleeve and gently tighten the 3 grub screws.
- Finally fit the outer cap over the inner turret and gently tighten the 3 x M4 grubscrews. If a small adjustment to zero is required, simply loosen the 3 x M4 grubsrews, set zero and tighten back in position.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>