Ladvow LDW-1956-2 Solar Spotlights User Manual
- March 14, 2024
- Ladvow
Table of Contents
Ladvow LDW-1956-2 Solar Spotlights User Manual
Brief Introduction
This product is the new generation spotlight, updated from previous version, this spotlight equipped 13 LEDs, upto 600 Lumen output. It is waterproof for outdoor. Automatic Switch- Auto on at night / Auto off at sunrise. Long working time, with built-in lithium rechargeable battery (3000mAh), it can light up 8-12 hours after it is fully charged(at Low light mode).
This product is versatile, it has a spike for sticking into the ground,
it also has a base for wall mounted, wall mounted accessories included in the package. It is perfect for garden, fences, wall, yard, stair, garage, cellar, attic, front porch, balcony, walkway, driveway etc.
The package includes:
1 x Spotlight
1 x Pole
1 x Spike
3 x Screws
3 x Expansion pillars
Specifications
| Solar Panel: | Polycrystalline 5V 2W, 18% efficiency |
|---|---|
| Battery: | Lithium 3.7V3000mAh |
| Light Source: | Lithium 3.7V3000mAh |
| Working time: | 13 LED |
| Charging time | 8-12 hours/Low, 6-8 hours/Hight |
| Lumen | 4-5 Hours under direct sunlight |
| Color | Hight mode:600LM, low mode:200LM |
| Temperature: | 3000k 6500k |
| IP Grade: | IP65 |
| Main Material: | ABS,PC |
| Crust Color: | Black |
| Switch Type: | On/Off switch |
| Function | Equipped with light sensor, the light turn off and charge during the |
day, turn on at night.
How to use
Turn on the switch:
The switch is located as the picture Fig 3 shows. Turn on the switch, the lamp
will start to work automatically (the product has a light sensor built-in to
enable the lamp to turn off light & charge during the day and turn on the
light during the night full automatically).
Installation:
Please pick a location where the product can have adequate amount of sunlight. Two ways of installation: spike for ground (Fig 4 ),
and use the screws to mount onto walls (Fig 5).
Adjustment:
The lamp is flexible in adjusting the angle of the spot light and the solar panel. The spotlight lighting projector can be adjusted by 148 degrees.
Battery replacement
The performance of the battery may decrease over time(usually about 1-2 years), please replace the battery as picture Fig 7.
Notes
- It is important to install the light in a location that receive full sunlight each day for at least 4-5 hours, away from the shade caused by trees, buildings etc. Shady locations will reduce the hours of night time light.
- Please handle carefully, avoid rough handling and collision.
- Dispose the used battery properly! DO NOT DISPOSE THE BATTERY IN FIRE!
Maintenance, troubleshooting
- Before use the solar light for the first time, leave the light under direct sunlight for about 36-48 hours. The light will achieve optimum light output after the enormous exposure to the sunlight.
- Please keep the surface of the solar panel clean, to make sure the product works at it’s best performance.
- It is important to install the light in a location that receive full sunlight each day, away from the shade caused by trees, buildings etc. Shady locations will not allow the battery to be fully charged and will reduce the hours of night time light.
- This solar light include a built-in photo sensor, which detects the level of surrounding natural light and controls when the light will automatically switch on and off. The solar light should be placed at least 2 meters apart from one another and away from other night time lights sources as this might keep the solar lights from automatically turning on at dusk.
- The performance of the solar light is dependent on the geographical location, weather conditions and seasonal sunlight availability. On cloudy days and during winter, the solar light will not receive as much direct sunlight, resulting in reduced brightness and reduced operating time.