GLOWSHIFT 68RE Transmission Line T-Fitting Adapter Installation Guide

: May 15, 2024
: GLOWSHIFT

Table of Contents

GLOWSHIFT 68RE Transmission Line T-Fitting Adapter
Product Information
Product Usage Instructions
(FAQ)
INSTALLATION INSTRUCTIONS
contact
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

GLOWSHIFT 68RE Transmission Line T-Fitting Adapter

Product Information

Specifications

Brand: GlowShift
Warranty: GlowShift Limited Warranty
Revision: 2024
Website : GlowShift Warranty Policies

Product Usage Instructions

Installation

Ensure the product is compatible with your vehicle.
Follow the installation manual provided with the product.
Securely mount the product in the desired location.

Operation

Turn on the product using the designated power button.
Adjust settings as needed using the control interface.
Monitor the product for any alerts or notifications.

Maintenance

Regularly clean the product using a damp cloth.
Check for any loose connections or damaged parts periodically.
Refer to the user manual for specific maintenance instructions.

(FAQ)

Q: What is covered under the GlowShift Limited Warranty?
A : The GlowShift Limited Warranty covers manufacturing defects and malfunctions under normal use conditions. Refer to the warranty policies for detailed information.
Q : How can I claim warranty service for my GlowShift product?
A : To claim warranty service, visit the GlowShift website and follow the instructions provided in the warranty policies section.

INSTALLATION INSTRUCTIONS

Disconnect the battery cables from the negative posts of both batteries.
Locate the cooler feed line on the passenger side of the transmission housing. Note: The upper line is the cooler feed line and the lower line is the return line from the cooler.
Cut 1 7/8” out of the cooler feed line with a pipe cutter. Note: It may be helpful to remove the bracket that holds the line in place to make it easier to use the pipe cutter. You can also remove the cooler feed line entirely from the truck and cut it on a workbench. If the cooler feed line is removed from the truck, up to 4 quarts of transmission fluid will need to be drained from the system and must be refilled with fresh transmission fluid once the T-fitting has been installed.
Identify a sufficient location between the bends in the cooler feed line and measure 1 7/8” and make a mark. Using a straight edge, draw a 5-7” line on the cooler feed line directly at the center of the 1 7/8” mark. This line will extend out passed the length of the cooler line T-fitting, which will help align both cut pieces of the cooler line.
Use the pipe cutter and cut the 1 7/8” section out of the line. Deburr both ends of the cut line with a deburring tool or an Emory cloth to ensure proper fitment of the T-fitting onto the cooler feed line.
Install the cooler line T-fitting female fittings over each end of the cut line. Then place the metal cutting rings over each end of the cooler line.
Hold the body of the T-fitting with a wrench and hand tighten each nut. Then tighten 1 1/4 more turns with a 7/8” wrench to ensure proper sealing of the cutting rings.
Now you can install the 1/8-27 NPT temperature sensor into the port on the T-fitting housing.
Note: Be sure to use Teflon tape on the threads of the temperature sensor to prevent any leaks.
If the line was removed, reinstall the line onto the truck and refill the transmission with up to 4 quarts of proper grade transmission fluid. Note: Check the dipstick to ensure the proper amount of fluid is in the transmission.
Reconnect the battery cables to the negative posts of each battery and check for any leaks.

GLOWSHIFT-68RE-Transmission-Line- T-Fitting-Adapter-
fig-2

All GlowShift Products are subject to the GlowShift Limited Warranty. Please visit https://www.glowshiftdirect.com/warranty-policies to review the complete Warranty, Terms, and Conditions.