rako RDA-800 0-10V/DSI/DLI Dimmer Instruction Manual
- May 15, 2024
- rako
Table of Contents
****
rako RDA-800 0-10V/DSI/DLI Dimmer
For more information relating to the RDA-800, see the Wireless Module
Application Sheet, Wireless RAK Application Sheet, and Wireless Device LED
Diagnostics.
For programming a wireless system: Wireless Module Setup Guide
What is the RDA-800?
The RDA-800 is a multifunctional dimming unit designed for controlling 0-10V, DALI, or DSI drivers. Drivers can be controlled on the mains input using the built-in 800VA relay.
Loadings
installation
Installation should only be carried out by a competent electrician.
- RDA-800 modules should be mounted in areas that are adequately ventilated, dry, and outside of any enclosed metal casings that may interfere with the wireless signal.
- Modules should be mounted vertically, with the terminals at the bottom, or horizontally.
- While the modules are designed to be maintenance-free, they should be mounted in an accessible location should investigation or re-addressing of the units be necessary.
- Ensure that the cable clamps are fitted tightly to secure the cables.
Initial checks
- When power is initially connected to the module, the load should power up to full brightness.
- The clear button can be used as a manual on/off switch to test the circuit.
- The internal LED behind the clear button will flicker when the module receives any Rako wireless message is a useful diagnostic indicator.
- The LED feedback becomes inactive after 20 minutes to avoid a nuisance light spill but can be re-activated by pressing the clear button.
Programming the RDA-800
Once the RDA-800 has powered up and has been tested working with the setup
button, the device is ready to be programmed. For instructions on how to
program the RDA-800, see the Wireless Module Setup Guide.
Appendix 1: LED Diagnostics
Should the module not respond to any of the above, check the supply voltage. Thank you for choosing Rako Controls; we hope that you are pleased with your system. Should you require further assistance, please contact us via our website, www.rakocontrols.com, or by calling our customer support helpline on 01634 226666.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>