Folews 4 Tier Metal Shelf for Storage Installation Guide
- May 15, 2024
- Folews
Table of Contents
Folews 4 Tier Metal Shelf for Storage Installation Guide
Contents:
If there are any missing parts, please contact us before assembly via email at cs@folews.biz
A – 4 x Shelves
B – 36 x Joint clips
C – 4 x Bottom poles
D – 4 x Top poles
E – 4 x wheels
F – 4 x Leveling feet
G – 2 x Hangers
H – 1 x Flat washer
I – 1 x Expansion screw
J – 1 x Screw
Installation:
-
Install the 4 wheels into the bottom poles(C).
NOTE: Both the wheels(E) and leveling feet(F) can be adjusted to keep the shelf stable. -
Install the bottom shelf:
Place two joint clips (B) into the appropriate groove on each pole as below (8 joint clips in total). Ensure the arrows on the clips are facing upwards. Gently slide down one shelf (A) through the bottom pole (C) until it fits firmly against all the joint clips (B). Ensure that it is no more than 6 inches from the floor.
NOTE: The joint clips (B) for each pole must be at the same height to ensure that the shelf is level.
-
Repeat step 2 to install one more shelf (A). Choose a suitable height between each shelf.
-
Screw the top poles (D)to the bottom poles (C).
-
Repeat step 2 to install the remaining 2 shelves(A) and the 2 hangers (G). Choose a suitable height between each shelf.
Tips:
**Use the flat washer(H), expansion screw(I), and screw(J) to fix the whole
shelf on the wall to prevent tip-over:
**
- Screw the expansion screw(I) into the wall, at the top shelf.
- Put on the flat washer(H), and screw the screw(J) into the wall.
Safety Information：
- Recommended to be installed by two adults. Be careful when handling.
- Recommended to install on a soft surface, such as carpet, to prevent scratching the floor finish.
- The black circular plastic pieces are only used to separate and protect the shelves during shipping.
CAUTION: Do not allow children to climb or play in or around the shelves.
