RmItaly KL7505 HAM Linear Amplifier Linear Amplifier User Manual

May 15, 2024
RmItaly

KL7505 HAM Linear
Amplifier Linear Amplifier
User Manual

INSTALLATION NOTE CONNECTION DIAGRAM

This device must be installed in an area where there is adequate ventilation for the heat sink.
The amplifier is not designed for continuous transmission and should not be operated in this manner. Failure to observe this will cause the amplifier to shut down from excessive temperature.
If the amplifier is operated in high ambient temperatures transmission times should be kept short to avoid excessive heat sink temperature. Excessive heat sink temperature will cause the amplifier to shut down transmission. This is indicated when the TX LED flashes.
If this occurs operation of the amplifier should be stopped and the amplifier will regain normal operation when the temperature falls to an acceptable level. This may take more than 5 minutes.
ANTENNA 50Ω FREQUENCY RANGE EQUAL TO OR GREATER OF 28-30MHz 10 METERS BAND MAXIMUM POWER SUPPOR- TED BY ANTENNA NOT LESS THAN 240W

RmItaly KL7505 HAM Linear Amplifier Linear Amplifier - LED
flashes

FRONTPANEL

RmItaly KL7505 HAM Linear Amplifier Linear Amplifier - FRONT
PANEL

[ Power On Led]
\ Transmission state indication LED, if blinking indicates a overtemperature. To restore turn off and tum on, again, the device.
Power On switch
∧ Modulation type selection (delay return to receive mode)

  • AM/FM 0 _ Seconds Delay
  • F-SSM 0.8 Seconds Delay
  • S.SSB 1.2 Seconds Delay

Gain selection

  • HI l4db ±1
  • MID 12db ±1
  • LOW 8db ±1

BACK PANEL

RmItaly KL7505 HAM Linear Amplifier Linear Amplifier -
backPANEL

TX/TX 50Q Connector to be connected to your radio transceive MAXIMUM POWER-IN 10W
ANT 50Q Connector to be connected to a proper antenna for the frequency in use
13.5V Supply. Lower or unstable voltages compromise device performance

GENERAL SPECIFICATIONS

POWER SUPPLY
Working voltage from 11V to 14V
Maximum current consumtion 30A
30A Safety Fuse
RF PERFORMANCE
Frequency range 28-30MHz
10 METERS BAND
Maximum Gain |Sdb
Maximum Pover IN LOW (Higher powers may permanently damage the device)
Maximum Pover OUT 240W
www.rmitaly.cominfo@rmitaly.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals