Maestro MR-075 Electric Kettle Owner’s Manual
- May 15, 2024
- MAESTRO
Table of Contents
Owners manual. Electric kettle
Model: MR-075
MR-075 Electric Kettle
Dear customer, we thank you for purchase of goods
Functionality, design and conformity to the quality standards guarantee to you
reliability and convenience in use of this device.
Please read and comply with these original instructions prior to the initial
operation of your appliance and store them for later use of subsequent owners.
The kettle is designed only for warming and boiling water for home use.
Under condition of observance of user regulations and a special- purpose
designation, a parts of appliance do not contain unhealthy substances.
Technical specifications
Model: MR-075
Capacity: 2,0L
Electrical supply:
Alternating current- AC;
Rated voltage 220-240V;
Rated frequency 50Hz;
Power consumption 1500W
Protective class I
Protection class IPX0
Description of the appliance
Picture1 (page 2)
A- Cover;
В- Handle for cover opening;
C- Switch button with indicator light;
Position «0» – OFF
Position «I» – ON
D- Handle;
E- Kettle case;
F- Base.
Safety instructions
When using your appliance, basic safety precautions should always be followed,
including the following:
SPECIAL INSTRUCTIONS
ATTENTION!
– Do not allow the ingress of water and moisture on the support and internal
electric parts of the device located outside the container for water.
– Always remove the kettle from the support to fill it with water or to clean.
– Do not touch the water in the kettle when it is on the support.
Failure to observe these rules may result in electric shock!
Only plug the appliance into an outlet with an earthed (ground) contact.
– DO NOT let children or untrained persons use the appliance without
supervision.
– DO NOT leave the appliance unnecessarily plugged in.
Disconnect the plug from the mains when the appliance is not being used.
– DO NOT use the power cord or the appliance in order to pull the plug out of
the socket.
– DO NOT leave the appliance exposed to the weather (rain, sun, etc. ).
– DO NOT leave the appliance without supervision when it is connected to the
power supply.
– Close supervision is necessary when the appliance is used near children.
– Always use the appliance on a dry, level surface.
– Do not put on and take off the kettle from the support when it is switched
on. First, turn it off with a switch.
– Always unplug from the plug socket when not in use and before cleaning.
– Do not operate the appliance if damaged, after an appliance malfunctions or
it has been damaged in any manner, return to at authorized service engineer
for repair.
– In the interest of safety, regular periodic close checks should be carried
out on the supply cord to ensure no damage is evident. Should there be any
signs that the cord is damaged in the slightest degree, the entire appliance
should be returned be authorized service engineer.
– Do not let the cord hang over the edge of a table or counter or touch hot
surfaces. Allow unit to cool before storage.
– Do not touch any hot surfaces, do not store or cover the appliance until it
has full cooled down.
– Do not use harsh abrasives, caustic cleaners or oven cleaners when cleaning
this appliance.
– This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
– Children should be supervised to ensure that they do not play with the
appliance.
– Do not leave the kettle switched on if the temperature in the room may fall
below zero. When the temperature is below zero, the thermostat of the device
may spontaneously turn on and switch on the device.
ATTENTION!
– The surface of the device becomes very hot during operation.
Be careful because you may burn yourself greatly by touching the surfaces of
the cover, case, water of vapor.
– Do not open the cover of the kettle during boiling.
– Do not lift the kettle by its cover.
– Take and lift the kettle only keeping it for the handle, touch only the
buttons of the device.
– Do not fill the kettle with the water level higher than the mark «MAX».
– Place the kettle only on a dry, stable, even, slip-resistant surface.
– Lift the kettle full with hot water with special care!
In case of failure to observe the above mentioned rules there arises the
danger of burning!
– To avoid possible damages by vapor turn the kettle nose away from walls and
furniture when it is boiling. Use the support to save the sensitive cover of
furniture from damages.
– Do not place the kettle and its support on heating devices.
– Do not close the opening for the exit of vapor near the switch.
– Do not use the kettle without a cover.
– Do not switch the kettle on without water or when the water level is below
the mark «MIN». If the kettle is empty or there is not enough water in it, it
is automatically turned off by safety device. In such case, disconnect the
device from the mains, let it cool down and then fill it with water again and
turn it on; the kettle will begin to boil water and after the end of this
process it will turn off in the regular regime.
– THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOTUSE THE APPLIANCE FOR
ANYTHING OTHER THAN INTENDED USE.
Purchase industrial devices for commercial use.
Actions in extreme situations:
– If a device tumbled into water, immediately, unplug the device, not touching
to the device or water.
– In case of appearance from appliance of smoke, sparkling, strong smell of a
burn isolation, immediately stop use the device, unplug the device, appeal to
the nearest service center.
Operation
Before the first use:
– Remove packing and advertising materials and stickers.
– Inspect the kettle and make sure that there are no damages to the kettle,
power line cord, plug and support.
– Unwind the power line cord completely.
– Place the support on a dry, even, stable surface.
CAUTION! Is required on surfaces where heat may cause a problem – an
insulated heat pad is recommended.
– Connect the plug to the mains.
– Remove the kettle from the support.
– Open the cover, fill the kettle with cold water up to the mark «MAX» (the
water level scale with «MIN» and «MAX» marks is inside). Close the cover.
– Place the kettle on the support.
– Turn the switch (C/ Fig.1) to the position «I». The indicator will light
signaling that the device has turned on, and the kettle shall begin warming
the water.
– When the water begins to boil, the switch will be turned to the position «О»
(off), the light will fade and the kettle will be automatically turned off.
– You must pour out the first portion of water and repeat the boiling
procedure again.
– Now the kettle is ready for use.
ATTENTION! Do not fill the kettle with cold water until cools down; let
it get cool before filling with cold water.
Failure to observe this rule may result in the damage to the ceramic case.
Further boil water as specified above.
The level of water in the kettle must be somewhere between the marks «MIN» and
«MAX».
The process of warming the water can be interrupted at any moment by pressing
on the switch.
ATTENTION! If your kettle switches off before the water begins to boil,
you should clean it of scale (see cleaning and maintenance).
The kettle can continue operation if its cover is open.
Cleaning and maintenance
Regular cleaning improves the performance of the device.
The quantity and the speed of forming the scale, and consequently, the
necessity of cleaning depend on the water hardness in your region and the
intensity of the device usage. All over fur of scale in your kettle is not
allowed!
It is recommended to clean the kettle at least 2 times a year but however
until the appearance of all over scale.
ATTENTION!
– Never clean a kettle connected to mains.
– Before cleaning, disconnect the kettle and let it cool down.
– Do not use abrasive and aggressive detergents.
– Never submerge the kettle, its support, power line cord and plug in water or
other liquids.
Cleaning the kettle from scale
Clean the kettle from scale with special agents sold in the open market.
Cleaning from scale can be also performed by the methods described below:
METHOD 1
– Fill the kettle to maximal level with a mixture consisting of 1 part of
usual vinegar and 2 parts of water. Switch on the kettle and let is boil and
automatically switch off.
– Let the mixture settle during 10-12 hours and pour it out.
– Fill the kettle with fresh water up to maximal level and boil it again.
Pour out this water too to remove the smell of vinegar.
-Wash the internal part of the device with clean water, wipe it and dry the kettle.
METHOD 2
– Fill the kettle with the above mentioned mixture of water and vinegar and
boil it 2 or 3 times running. Rinse it with water and rub it dry.
– For usual cleaning wipe the kettle case from the inside and outside with a
soft wet sponge or cloth. Soapy water can be used.
– Rinse the kettle and wipe it dry.
– Let the device get fully dry before using.
– Any other kinds of maintenance should be performed by qualified personnel in
a servicing center.
Storage
– Switch off the kettle and let it completely cool before storage.
– Wipe and dry the kettle before storage.
– Do not wind the power line cord around the kettle until it is completely
cooled down.
– Store the kettle in a cool, dry and clean place beyond the assess of
children and people with limited physical and mental abilities.
Environmental protection
Old appliances contain valuable materials that can be recycled. Please arrange
for the proper recycling of old appliances. Please dispose your old appliances
using appropriate collection systems.
Subject to technical modifications!
Сertificated in Ukraine
feel-maestro.eu
Made in P.R.C. for Maestro
Apollo Corporation Limited ADD: Room 801-2, 8/F.,
Easey Commercial Building, 253-261 Hennessy Road, Wanchai, Hong Kong,
EN 60335-2-15:2015
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>