ADT XPF01 Flood and Freeze Sensor User Guide
- May 15, 2024
- ADT
Table of Contents
ADT XPF01 Flood and Freeze Sensor
Product Specifications:
- Product Name: Flood & Freeze Sensor
- Model Number: XPF01
- Main Sensor: Included
- Power Source: Cell Battery
- Installation Steps: 2
- Placement: Under sink, refrigerator, or near water sources
Product Usage Instructions
Prepare the Main Sensor:
Add Flood/Freeze Sensor to your panel. Getting your Flood/Freeze Sensor up
and running is as simple as pressing the button and adding it to the panel.
Change Battery:
- Take the screw cover of the sensor casing out using a screwdriver to remove the hardware from the plastic casing.
- Pull out the screws from the plastic casing to change the battery.
- Take the front cover out and remove the cell battery as shown in the picture.
- Use a screwdriver to take out the cell battery.
Install Your Flood & Freeze Sensor:
With the sensor powered and activated, it is time to install it within your
selected area. For optimal performance:
- Place the Flood and Freeze Sensor on the floor or any flat surface under a sink, refrigerator, or any other water source.
- Get alerts when water or low temperatures are detected.
FAQ:
-
Q: How do I connect the Flood & Freeze Sensor to the **panel?
** A: Press the button on the sensor and follow the instructions to add it to your panel. -
Q: Where is the best place to install the Flood & Freeze **Sensor?
** A: It is recommended to place the sensor on the floor under a sink, refrigerator, or near any water sources for optimal performance.
Flood/Freeze sensor
Flood/Freeze sensor (XPF01) is designed for indoor residential and light commercial use. The Flood/Freeze sensor can be easily installed under sinks, near showers, tubs, toilets, dishwashers, fridge, washing machines, water heaters, basements, and other areas where water may accumulate or pool. It communicates with XP02 Control Panel over 433 MHz frequency. Signals are transmitted to the alarm control panel when it detects a wet, dry (Loop 1) or freeze (Loop 2) condition. Flood/Freeze sensor is comprised of one part: the Main Sensor.
- The larger Main Sensor
The installation of your Flood & Freeze Sensor has two key steps:
- Install both parts of Flood & Freeze sensor.
- Connect Flood & Freeze sensor to the panel.
Prepare the Main Sensor
Add Flood/Freeze Sensor to your panel.
Getting your Flood/Freeze Sensor up and running is as simple as press the
button, and adding it to panel.
Change battery
Please follow the below process.
- Take the screw cover of the sensor casing out using a screw driver for pulling out the hardware from the plastic casing
- Pulling out the screws from the plastic casing to change the battery.
- Take the front cover out and pull out the cell battery as the picture.
- Take the cell battery out using a screw driver for pulling out the cell battery as the picture.
Install your Flood & Freeze Sensor
With the Sensor powered and activated, it is now time to install it within your selected Flood & Freeze sensor. Before beginning, it is important to select a suitable position for your Flood & Freeze Sensor.
For optimal performance
Place the Flood and Freeze Sensor on the floor or any flat surface under a
sink, refrigerator or any other water source, and get alerts when water or low
temperatures are detected.
Please refer to below
Documents / Resources
| ADT
XPF01 Flood and Freeze
Sensor
[pdf] User Guide
XPF01 Flood and Freeze Sensor, XPF01, Flood and Freeze Sensor, Freeze Sensor
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>