Niccy Oval LED Bathroom Vanity Mirror Instruction Manual
- May 15, 2024
- Niccy
Table of Contents
Niccy Oval LED Bathroom Vanity Mirror
Installation Instructions for LED Mirror
- Installation tools (as shown below)
- Make certain the wall is solid, and the main electricity supply has been power-off
- Open the carton and make sure all the parts listed below are present
METHOD ONE
- Use the flexible rule to measure the center distance between two hardy holes on the mirror (Distance A)
- mark a desired height of the mirror. Choose the churn drill with an appropriate drill bit to make two holes on the marked places.
- Use the hammer to strike the expansion rubber plug in accessory bag into the holes on the wall, and then use a screwdriver to tighten the screws into the holes.
- Hang the mirror onto the screw crossing two hardy holes to fixed it.
METHOD TWO
- Put the long hanging piece in the accessory on the flat wall, and mark the positions of the two hard holes.
- Choose a mixing drill with a suitable bit and make two holes in the marked places.
- Use a hammer to tap the expansion plug from the accessory bag into the hole in the wall, then use a screwdriver to screw the screws through the two holes of the long hanging piece into the hole. If mirror is broken or if you have any other questions, please contact us niccyservice@outlook.com
- Hang the mirror on this long hanging piece, this way you can move the mirror side to side, but be careful not to let the mirror slip off the long strip.
Operating instruction
Turn on LED light and anti fog funtion
- Power on, short press to turn the light on, press the sensor again to turn the light off.
- Press the sensor , When anti fog function is turned on, the sensor is in blue light.
Adjust the LED brightness and light color
- Long press the touch switch to adjust the LED light brightness(from 3000K-6000K).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>