Niccy B098JGG3K2 24 Inch LED Round Mirror Installation Guide
- May 15, 2024
- Niccy
Table of Contents
Niccy B098JGG3K2 24 Inch LED Round Mirror
Product Information
- Specifications:
- Product: LED Mirror
- Features: LED light, anti-fog function, touch sensor
Product Usage Instructions
- Installation:
- Ensure you have the installation tools provided.
- Make sure the wall is solid and the main electricity supply is turned off.
- Mark the desired height for the mirror on the wall.
- Use a churn drill with an appropriate drill bit to make two holes in the marked places.
- Insert the expansion rubber plug into the holes and tighten the screws with a screwdriver.
- Check all parts in the carton are present.
- Measure the centre distance between two hardy holes on the mirror (Distance A).
- Hang the mirror onto the screws crossing two hardy holes to fix it securely.
- Switch on the power and test the product by touching the sensor.
- Operating Instructions:
- To turn on the LED light and anti-fog function, short-press the sensor. Press again to turn on the anti-fog function.
- To adjust the LED brightness and light colour, long press the touch switch to cycle through brightness settings (from 3000K to 6000K).
- To turn off the LED light and anti-fog function, press the sensor again while they are working.
FAQs
- Q: How do I adjust the LED light brightness on the LED Mirror?
- A: Long press the touch switch to adjust the LED light brightness between 3000K to 6000K.
- Q: How do I turn on the anti-fog function?
- A: Short press the sensor to turn on the LED light, then press again to activate the anti-fog function.
- Q: What should I do if the mirror does not turn on?
- A: Make sure the main electricity supply is turned on and check if the sensor is being touched correctly to activate the mirror.
Installation Instructions
Installation Instructions for LED Mirror
- Installation tools (as shown below)
- Make certain the wall is solid, and the main electricity supply has been power-of
- Open the carton and make sure all the parts listed below are present
- Use the flexible rule to measure the centre distance between two hardy holes on the mirror (Distance A)
- mark the desired height of the mirror. Choose the churn drill with an appropriate drill bit to make two holes in the marked places.
- Use the hammer to strike the expansion rubber plug-in accessory bag into the holes on the wall, and then use a screwdriver to tighten the screws into the holes.
- Insert the plug.
- Hang the mirror onto the screw crossing two hardy holes to fix it. Finally, switch the power, and touch the sensor to test the product.
Operating Instruction
- Turn on the LED light and anti-fog function
- Power on, short press to turn the light on, and press the sensor again to turn the anti-fog function on. When the anti-fog function is turned on, the sensor is in blue light.
- Adjust the LED brightness and light colour
- Long press the touch switch to adjust the LED light brightness (from 3000K-6000K)
- Turn off the LED light and antifog function
- When the LED light and anti-fog are working, press the sensor again to turn them off.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>