Kadision VFO100-50KFP 8FT LED Vapor Tight Light Fixture Instruction Manual
- June 17, 2024
- Kadision
Table of Contents
Kadision VFO100-50KFP 8FT LED Vapor Tight Light Fixture
Specifications
- Model: VFO100-50KFP
- Watts: 60W/80W/100W Adjustable
- Lumen: 13000lm (Maximum)
- Voltage Range: 100-277Vac
- Color Temp: 5000K
- Dimmable: 0-10V Dimming (Dimmer Not Included)
- Warranty: 5 Years
- Dimensions:
- Height: 4.7″ (120mm)
- Length: 80.7″ (2050mm)
- Width: 94.5″ (2400mm)
- Depth: 3.1″ (80mm) – 3.7″ (95mm)
- Hardware Included:
- A – Mounting Bracket (Quantity: 4)
- B – Water-tight Cable Gland (Quantity: 1)
- C – V Clips (Quantity: 4)
- D – Washers (Quantity: 8)
- E – Plastic Anchors (Quantity: 8)
- F – Mounting Screws (Quantity: 8)
- G – Wire Nuts (Quantity: 2)
Product Usage Instructions
Installation Instructions (Ceiling/Wall Mount)
- Install mounting bracket to ceiling with correct spacing.
- Lift fixture housing to mounting brackets and snap in place.
- Install the water-tight cable gland on the end of the fixture, feed wires into the housing through it, and tighten it. Make wire connections.
- The wattage switch is located inside the fixture. Slide the switch to adjust the light output.
- Check male/female DC connectors and all safety ropes. Ensure all connections are proper and secure.
- Re-attach the diffuser by fastening all latches.
End-to-End Connection
The maximum quantity for a daisy chain is 4 units (not to exceed 480W in total). Additional water-tight fittings need to be purchased.
FAQ
-
Q: Is the dimmer included with the fixture?
A: No, the dimmer is not included. It requires a separate purchase. -
Q: What is the warranty period for this product?
A: The product comes with a 5-year warranty.
INSTALLATION INSTRUCTIONS
PLEASE READ CAREFULLY AND SAVE THESE INSTRUCTIONS, AS YOU MAY NEED THEM AT A
LATER DATE
DIMENSION
HARDWARE INCLUDED
Mounting hardware is included in the fixture. Open the fixture by releasing all the latches on both sides of the fixture. Make sure that no parts are damaged or missing.
NOTE : Hardware not shown to actual size
Description
| Part | Description | Quantity |
|---|---|---|
| A | Mounting Bracket | 4 |
| B | Water-tight Cable Gland | 1 |
| C | V Clips | 4 |
| D | Washers | 8 |
| E | Plastic Anchors | 8 |
| F | Mounting Screws | 8 |
| G | Wire Nuts | 2 |
WARNINGS AND CAUTIONS
- All electrical connections must be by local National Electrical Code (N.E.C) standards. Installation must be performed by a qualified installer
- To avoid the possibility of electrical shock or fire, the installation personnel must have professional electric knowledge.
- All wiring connections should be capped with IEC-approved wire connectors.
- If the product is damaged, do not use it.
- The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
INSTALLATION INSTRUCTIONS (Ceiling/Wall Mount)
- Install mounting bracket to ceiling with correct spacing.
- Lift fixture housing to mounting brackets and snap in place
- Install the water-tight cable gland on the end of the fixture, feed wires into the housing through it and tighten it. Make wire connections
- Wattage switch is located inside the fixture. Slide the switch to adjust light output
- Check male/female DC connectors and all safety ropes. Make sure all connections are proper and secure.
- Re-attach the diffuser by fastening all latches.
End to End Connection
The maximum quantity for a daisy chain is 4 units (not exceeding 480W in
total). Additional water-tight fittings need to be purchased.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>