Bejoan 7.06.07.501-01 X1 Elongated Bidet Toilet Seat Instruction Manual

Bejoan 7.06.07.501-01 X1 Elongated Bidet Toilet Seat

Guide to installation of smart toilet seat

Prepare tools

• Cross screwdriver
• Tape measure
• wrench
• Cup
  Recommendations for power supply and water inlet connection

Part 1

1. Press and hold the disassembly button, pull out the base bracket.
2. Press and hold the disassembly button, pull out the base bracket.
3. Place the base bracket, cross screws, and bolt brackets in turn on the mounting holes of ceramic toilet.
4. Screw the cross screw into the rubber fixing sleeve and fix the bolt bracket and base bracket into the ceramic.
5. Align the bottom of the toilet seat with the direction of the base bracket, lift the rear part of the toilet seat slightly upward, and then slide to the base bracket until you hear the “click” sound.

Part2

1. Water supply hose and water diversion Valve
   Installation:

2. Close the water Supply valve and remove the water supply hose connected to the ceramic;

3. Install adapters at both ends of the water diversion valve;

4. Install the water diversion valve on the water supply valve;

5. Install the ceramic-connected in let pipe on the water diversion valve
   Note:
   Be sure to tighten it during installation, otherwise it may cause water leakage.

6. Make sure that the a-sealing ring part of the water supply hose is not attached with dust, and insert it straight into the connection part on the body side.
   Note:
   Make sure that the front of the water supply hose is equipped with an a-sealing ring. Do not cut 1 the water supply hose. Do not use the old water 1 supply hose, otherwise it will leak due to aging . 1 Do not allow the water supply hose to be

7. scratched by sharps.The water supply hose must be inserted straight to avoid the

8. a-sealing ring being engaged by the body connection.

9. Insert the fastener into the connection between the water supply hose and the body connector. (until hearing a “bang” sound).

10. When holding the water supply hose, turn the fastener slightly, and make sure that there is no obstacle when turning. If there is obstacle when turning, it is indicated that the installation is not correct.

11. Confirm whether the fastener is firmly fixed. Slightly pull the water supply hose and confirm that the water supply hose will not be separated from the main body

12. Confirm that all the interfaces have been connected, please turn on the water supply valve.

Prompt:
if water the toilet supply is hose, narrow, the and water after supply installing hose the can be body, if installed it is into difficult the to body, install and the then the body is installed to the ceramic.

Installation of Main Remote Control

• Select a suitable and dry surface, tear off the sponge double-sided adhesive, and fix the remote control hanger.
• Insert remote control into the hanger. ( It is recommended to fix the remote control in a ventilated and easy-to-use position; remove the battery in case of long-time idle.)

Connect the power supply
Press the “Test” key to confirm that the indicator light goes out and confirm that the product will stop working. If there is no problem with the above content,press the “Reset” key and the product will restart.
Appearance in kind prevail

• Open the water source and wait for the completion of the product’s water supply self-inspection.
•  After press the women wash/hip wash button to check whether the nozzle works normally.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>