LLURIA D-JE19 LED Strip Instruction Manual

Table of Contents

LLURIA-D-JE19-LED-Strip-product

Specifications:

Product Name: Waterproof IP67 Digital Juno Estanca 19,2W/m D-JE19,2 RGBW UCS512H4
Reference: D-JE19,2-RGBW-6P
Colours: Red, Green, Blue, 3000K
Luminous Flux per meter (Lm/m): Red – 155, Green – 395, Blue – 85, 3000K – 600
Power: 19.2W/m, Roll power for 5m – 96W
IP Rating: IP67
Voltage: 24V
LED Type: 5050
LED Quantity: 60 LEDs per meter

Installation:

Ensure the surface where the LED strip will be applied is clean and dry.
Peel off the adhesive backing of the LED strip and carefully place it on the desired surface.
Connect the strip to the control system following the provided instructions.
Make sure the connections are secure and the power source is compatible with the LED strip voltage.

Control System Setup:

Connect the LED strip to the control system using the designated ports.
Familiarize yourself with the control system functions for adjusting colours, brightness, and modes.
Test the control system to ensure proper functionality before mounting the LED strip permanently.

Maintenance:

Regularly check for any loose connections or damage to the LED strip.
Clean the surface of the LED strip gently with a soft, dry cloth to remove dust or dirt buildup.
Avoid exposing the LED strip to direct sunlight or harsh weather conditions to prolong its lifespan.

FAQ:

Can I cut the LED strip to a custom length?
Yes, you can cut the LED strip at designated cutting points to achieve a custom length. Follow the cutting guidelines provided in the manual.
How do I address interference issues with other electronic devices?
To minimize interference, keep electronic devices that may cause interference (such as motors, fans, and washing machines) away from the LED strip installation area.
What should I do if I encounter issues with the control system?
If you experience problems with the control system, refer to the troubleshooting section in the manual or contact customer support for assistance.

High-quality flexible digital LED strip light.
Ideal for all types of installations, general lighting, accent lighting and decorative lighting.
For indoor use.

$LLURIA-D-JE19-LED-Strip-fig- $1$$

$LLURIA-D-JE19-LED-Strip-fig- $3$$

Respect the schematic that will be delivered with the position of each of the elements and the resupply.

$LLURIA-D-JE19-LED-Strip-fig- $4$$

Do not bend the LED strip to adapt them to a sharp radius or angle.
Check that the direction of the arrows or the text “LLURIA” is in the right direction.
Check the operation of the LED strip before placing it on the profile.
The installation of the system must be done without the power being switched on.
Avoid using the same ignition and wiring or putting LED strips near a 220V signal or devices that may cause interference (motors, fans, washing machines, etc.).
Follow the order of the installation according to the schematic.
Leave zones with registers to access amplifiers, sources and resupply.
Avoid passing wires in front of the LEDs in the installation to avoid shadows.
The section of the power wiring from the source to the different resupplies must have a minimum section of 1.5mm for lengths of 10m, 2.5mm for lengths of 20m and 4mm for lengths of 30m.

Lifetime

The lifetime of our LEDs is 50.000h at an ambient temperature of 23ºC and provided with a heat dissipation system.
Off cycles are recommended to extend the life of the LEDs.

To ensure the life of the LED, it is requested to place it on a surface that dissipates the heat it generates.
Caution when handling cables to avoid damage to the welds.
The voltage surges can cause damage.
If the diffuser is used with the dissipating profile, there may be variations in the colour temperature.

Lluria reserves the right to modify specifications.