XIHUAN 230215 Adjustable Over The Toilet Storage Floor to Ceiling Instruction Manual
- June 17, 2024
- XIHUAN
Table of Contents
XIHUAN 230215 Adjustable Over The Toilet Storage Floor to Ceiling
Product Information
- Specifications:
- Number of Shelves: 4
- Material: Steel
- Colour: Silver
- Dimensions: 24in x 12in x 48in
Product Usage Instructions
- Part 1: Assemble 4 Shelves
- Start by assembling the 4 shelves according to the provided instructions.
- Connect the thinner pipe to the corresponding hole of the thick pipe.
- Attach the thicker pipe to the bigger hole of the shelf bracket.
- Pull out a part of the thinner pipe from each thicker pipe and place two shelf brackets with thick tubes on the pipe. Connect the thinner pipe to the corresponding smaller holes of the shelf bracket.
- Note: Ensure that all shelves are placed on the wider pole for stability. The shelves should not be placed on the top slimmer poles.
- Make sure to screw the shelf buckle into the correct spiral track to ensure the tightness and stability of the rack.
- Connection Points:
- Slimmer Pole: Connection point for thinner pipes.
- Wider Pole: Connection point for thicker pipes.
- Frequently Asked Questions (FAQ)
- Q: Where should I place the shelves for stability?
- A: All shelves should be placed on the wider pole. Do not place them on the top slimmer poles for stability.
- Q: What should I do to ensure the rack’s stability?
- A: Make sure to screw the shelf buckle into the correct spiral track to tighten it properly and maintain stability.
Spare Parts
Read the instructions book carefully before you set up the product to avoid damaging the parts.
Warning
- Do not touch one end of the rod or around the screw holes. Maybe injured.
- Please place it in a horizontal and stable place. It may cause injury or damage to the equipment due to falling.
- Do not install a shelf on a pole near the ceiling.
- Please confirm the strength of the ceiling if the place in advance.
- This product is only for indoor use and must not be used outdoors.
- Please do not use this product near fire and heating equipment.
- Please use it after confirming that each part is firmly fixed.
- Please do not place, hang or lean on this product. It may cause injury or damage to the equipment due to falling.
- When there are children around, adults need to check on the side to confirm children’s safety.
- Please do not place things that exceed the loadable weight
- Please do not single-point weight bearing. Keep the object under the load.
- When moving this product, please remove the things placed.
Assemble
PART 1 Assemble 4 shelves
- Connect the thinner pipe corresponding to the thick pipe hole.
- Connect the thicker pipe to the corresponding bigger hole of the shelf bracket ⑦.
- Place two shelf brackets with thick tubes on the same level
- Pull out a part of the thinner pipe from each thicker pipe 4 and connect the thinner pipe to the corresponding smaller holes of the shelf bracket ⑦
- Press in tightly. Complete one shelf.
- Repeat the previous step for four shelves.
PART 2 Assemble poles and connect them
Install bottom cap 5 on bottom poleD. And connect poles 1 2 3 or D3 based on your needs.
PART 3 Located vertical poles in the position
Adjust the length of the vertical pole: Extend the pole length 2cm longer
than the height of the installation area (ceiling to floor).
After locating vertical poles in the position, please slightly shake the pole and make sure it stands solid.
Before setting the horizontal bar on the vertical poles, please make sure you’ve adjusted the bar brackets on a proper position and on the same horizontal line.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>