PEERLESS RP71609OB Slip on Tub Spout and Adapter Instruction Manual
- June 17, 2024
- Peerless
Table of Contents
SINGLE HANDLE WASHERLESS PRESSURE
BALANCED TUB & SHOWER VALVES
Models PTT188733,
PTT188763, PTT188763-LHD,
PTT188773 & PTT188773-LHD
Series69247
RP71609OB Slip on Tub Spout and Adapter
Write purchased model number here.
You may need:
Hole Dimensions (minimum and maximum hole size in wall for valve installation)
800-438-6673
www.peerlessfaucet.com/customer-support
WARNING Read these instructions before installation. The failure to read
and follow these instructions may result in personal injury or property damage
and may void the warranty.
CAUTION This pressure balanced device does not control or adjust for
temperature changes, only pressure fluctuations. As the installer of this
valve, it is your responsibility to adjust the valve per the instructions
given to insure safe, maximum temperature. The necessary Rotational Limit Stop
adjustments must be made at the time of installation.
Further adjustments may be necessary due to seasonal water temperature change.
Retain this instruction sheet for future reference.
WARNING It is necessary to adjust the Rotational Limit Stop so that the
water coming out of the valve will not scald the user when the handle of the
valve is rotated to the hot side. In some instances, setting the Rotational
Limit Stop in the hottest position (full counterclockwise) could result in
scald injury.
RECOMMENDED VALVE CONFIGURATIONS ON STRINGERS OR FRAMING
| TUB/SHOWER | SHOWER ONLY |
|---|
| 
BACK TO BACK INSTALLATION
Normal Installation (changes not required)
For back to back or reverse
installations (hot on right and cold on left) insert the cartridge with the
“hot side” on the right.
SHUT OFF WATER SUPPLIES
Remove old valve. Install new valve so that the arrows on the bracket (1)
point upward. Remove cover (2) and bonnet nut (3).
For shower only installation, plug bottom valve outlet with pipe plug (4) (not
supplied). Note: Distance (5) from the stringer (6) to the front of the
plaster guard is 2 3/4″ ± 1/4″ (70 mm ± 6 mm). This is the same distance to
the finished wall (7).
Connect water supplies to
left (hot) and right (cold) valve body inlets. Insert cartridge (1) into valve
with the hot side matching the hot inlet side. Slide the bonnet nut over the
cartridge and hand tighten securely.
FOR SHOWERHEAD INSTALLATION:
- Connect top outlet (1) to shower arm (2) with proper fittings. To prevent damage to finish on shower arm, insert wall end of shower arm into shower flange (3) before screwing arm into riser connection.
- Thread showerhead (4) onto shower arm.
- Apply plumber tape to pipe threads on both ends. Do not overtighten showerhead.
FOR TUB SPOUT INSTALLATION:
For models with tub spouts, the piping between valve body and tub spout must
be a minimum of 1/2″ (13 mm) copper pipe in a straight drop no less than 8″
(203 mm), but no more than 18″ (457 mm) long with copper 90° elbow to the tub
spout nipple.
Do not connect deck mount spouts to in-wall valves. Do not use hand showers
connected in lieu of a tub spout to a tub/shower valve. Do not use PEX or
PVC/CPVC tubing for tub spout drop.
A. SLIP-ON INSTALLATION:
The copper tube (1) must be 1/2″ nominal copper. Important: If it is necessary
to cut the copper tube, the end must be chamfered free of burrs to prevent
cutting or nicking o-ring inside the spout.
- Slide spout over copper tube flush with the finished tub or wall surface.
- Tighten set screw (2), but do not overtighten.
FLUSH SYSTEM / CHECK FOR LEAKS
- Place handle on valve stem and turn handle to full on mixed position.
- Turn on hot and cold water lines to full open for one minute each.
- Check for leaks.
- Shut off water at faucet.
TRIM INSTALLATION
- Remove handle (1).
- Slide o-ring (2) over bonnet nut, onto valve body.
- Attach escutcheon (3) with screws provided.
- Install spacer (4) into sleeve (5) and slide sleeve over cartridge and valve body.
- Adjust the rotational limit stop (see Step 7).
- After adjusting the rotational limit stop, secure handle with set screw.
WARNING: This system/device must be set by the installer to insure safe, maximum temperature. Any change in the setting may raise the discharge temperature above the limit considered safe and may lead to scald injury.
NOTICE TO THE INSTALLER: As the
installer of this valve, it is your responsibility to:
-
Properly INSTALL and ADJUST this valve per the instructions given.
• This valve does not automatically adjust for inlet temperature changes, therefore, the necessary Rotational Limit Stop adjustments must be made at the time of installation and further adjustments may be necessary due to seasonal water temperature change. -
Inform the owner/user of this requirement.
• After installation and adjustment, you must affix your name, company name and the date you adjusted the Rotational Limit Stop to the caution label provided and attach the label to the back side of the closet cabinet door and the warning label to the hot water heater. -
Leave this instruction sheet for the owner’s/user’s reference.
ADJUSTING THE ROTATIONAL LIMIT STOP:
• Turn on water so that cold water is as cold as it will get and hot water is as hot as it will get.
• Place handle back on stem and rotate fully counterclockwise to the hottest position.
• Place a thermometer in a plastic tumbler and hold in the water stream. If the water temperature is above 120°F, the Rotational Limit Stop must be repositioned clockwise to decrease valve outlet water temperature to be less than 120°F or to meet the requirements of your local plumbing codes. In that case, remove the Rotational Limit Stop and replace it one tooth counterclockwise for every 6°F (approximate) reduction in temperature that must be made. Repeat as necessary.
Make sure cold water flows from the valve first. Make sure water (at the hottest flow) does not exceed the temperature allowed by your plumbing codes (120°F or 110°F).
Cleaning and Care
Care should be given to the cleaning of this product. Although its finish is
extremely durable, it can be damaged by harsh abrasives or polish.
To clean, simply wipe gently with a damp cloth and blot dry with a soft towel.
THIS VALVE MEETS OR EXCEEDS THE FOLLOWING STANDARDS: ANSI A112.18.1, CSA B125
AND ASSE1016
Maintenance
SHUT OFF WATER SUPPLIES
If faucet leaks from around tub spout/showerhead:
Replace Seats and Springs (1) Repair Kit RP4993, or Valve Cartridge (3) Repair
Kit RP46074.
If leak persists:
Replace O-Rings (2), Repair Kit RP14414.
If unable to maintain constant water temperature:
Replace O-Rings (2), Repair Kit RP14414 or Valve Cartridge (3), Repair Kit
RP46074.
When replacing a part, follow the illustrated instructions provided on the
back of the Repair Part Kit.
Limited Warranty on Peerless® Faucets
Parts and Finish: All parts and finishes of this Peerless® faucet are
warranted to the original consumer purchaser to be free from defects in
material and workmanship for as long as the original consumer purchaser owns
the home in which the faucet was first installed. For commercial purchasers,
the warranty period is ten (10) years for multi-family residential (apartments
and condominiums) and five (5) years for all other commercial uses, in each
case from the date of purchase.
Parts and Finish for Peerless® Recertified Faucets: Peerless Faucet
Company offers for sale online Peerless® Recertified faucets. Peerless®
Recertified faucets only include faucets that have been certified as such by
Peerless Faucet Company. All parts (other than electronic parts and batteries)
and finishes of these Peerless® Recertified faucets are warranted to the
original consumer purchaser to be free from defects in material and
workmanship for ten (10) years from the date of original purchase. For
commercial purchasers, the warranty period is one (1) year from the date of
original purchase.
What We Will Do: Peerless Faucet Company will repair or replace, free of
charge, during the applicable warranty period (as described above), any part
or finish that proves defective in material and/or workmanship under normal
installation, use and service. Peerless Faucet Company may, in its sole
discretion, use new, refurbished or recertified parts or products for such
repair or replacement. If repair or replacement is not practical, Peerless
Faucet Company may elect to refund the purchase price in exchange for the
return of the product. These are your exclusive remedies.
What Is Not Covered: Any labor charges incurred by the purchaser to
repair, replace, install or remove this product are not covered by this
warranty. Peerless Faucet Company shall not be liable for any damage to the
faucet resulting from reasonable wear and tear, outdoor use, misuse (including
use of the product for an unintended application), freezing water, abuse,
neglect or improper or incorrectly performed installation, maintenance or
repair, including failure to follow the applicable care and cleaning
instructions. Peerless Faucet Company recommends using a professional plumber
for all installation and repair. We also recommend that you use only genuine
Peerless® replacement parts.
What You Must Do To Obtain Warranty Service or Replacement Parts: A
warranty claim may be made and replacement parts may be obtained by calling 1
800 438-6673 or by contacting us by mail or online as follows (please include
your model number and date of purchase):
In the United States and Mexico:
Peerless Faucet Company
55 E. 111th Street
Indianapolis, IN 46280
Attention: Warranty Service
https://www.peerlessfaucet.com/customer-support/contact-us
In Canada:
Masco Canada Limited, Plumbing Group
Technical Service Centre
350 South Edgeware Road
St. Thomas, Ontario, Canada N5P 4L1
https://www.peerlessfaucet.com/customer-support/contact-us
Proof of purchase (original sales receipt) from the original purchaser must be
made available to Peerless Faucet Company for all warranty claims unless the
purchaser has registered the product with Peerless Faucet Company. This
warranty applies only to Peerless® faucets manufactured after January 1, 2019
and installed in the United States of America, Canada and Mexico.
Limitation on Duration of Implied Warranties. Please note that some
states/provinces (including Quebec) do not allow limitations on how long an
implied warranty lasts, so the below limitations may not apply to you. TO THE
MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, ANY IMPLIED WARRANTY, INCLUDING
THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR
PURPOSE, IS LIMITED TO THE STATUTORY PERIOD OR THE DURATION OF THIS WARRANTY,
WHICHEVER IS SHORTER.
Limitation of Special, Incidental or Consequential Damages. Please note that
some states/provinces (including Quebec) do not allow the exclusion or
limitation of special, incidental or consequential damages, so the below
limitations and exclusions may not apply to you. TO THE MAXIMUM EXTENT
PERMITTED BY APPLICABLE LAW, THIS WARRANTY DOES NOT COVER, AND PEERLESS FAUCET
COMPANY SHALL NOT BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES (INCLUDING LABOR CHARGES TO REPAIR, REPLACE, INSTALL OR REMOVE THIS
PRODUCT), WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED WARRANTY,
BREACH OF CONTRACT, TORT, OR OTHERWISE. PEERLESS FAUCET COMPANY SHALL NOT BE
LIABLE FOR ANY DAMAGE TO THE FAUCET RESULTING FROM REASONABLE WEAR AND TEAR,
OUTDOOR USE, MISUSE (INCLUDING USE OF THE PRODUCT FOR AN UNINTENDED
APPLICATION), FREEZING WATER, ABUSE, NEGLECT OR IMPROPER OR INCORRECTLY
PERFORMED INSTALLATION, MAINTENANCE OR REPAIR, INCLUDING FAILURE TO FOLLOW THE
APPLICABLE INSTALLATION, CARE AND CLEANING INSTRUCTIONS.
Notice to residents of the State of New Jersey: The provisions of this
warranty, including its limitations, are intended to apply to the fullest
extent permitted by the laws of the State of New Jersey.
Additional Rights: This warranty gives you specific legal rights, and you may
also have other rights which vary from state/province to state/province.
This is Peerless Faucet Company’s exclusive written warranty and the warranty
is not transferable.
If you have any questions or concerns regarding our warranty, please contact
us as provided above or view our Warranty or FAQs under Customer Support at
www.peerlessfaucet.com.
© 2022 Peerless Faucet Company
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>