VIDALITE 702250U Karpo Single Spot Installation Guide
- June 17, 2024
- VIDALITE
Table of Contents
VIDALITE 702250U Karpo Single Spot
Installation Instructions
Safety Information
This luminaire must be installed in accordance with the National Electrical
Code and
- local electrical and construction regulations. To assure full compliance with local code and regulations, check with your local electrical inspector before installation.
- To prevent electrical shock, turn off electrical breaker and branch circuit switch.
- Do not exceed specified luminaire voltage. Use of any other source will void warranty.
- Do not install if the luminaire, parts, or connectors are damaged.
- The product must be installed with provided drivers and housings only. Use of other manufacturers’ components will void the warranty.
MAINTENANCE AND CARE:
Disconnect the product from the power supply before cleaning or maintenance.
INSTALLATION STEPS
-
Locate the LED driver and prepare for remote installation within the junction box.
-
Using UL-recognized wire nuts connect the building power wires to the LED driver.
-
Place LED driver into the Junction Box. 4 inch octagon box only.
-
Locate the mounting plate and LED module. Feed the LED module connector and ground wire through the mounting plate center hole.
-
Connect the LED driver (male connector) to the LED module (female connector.)
IMPORTANT – DO NOT connect fixture to a driver that is energized/powered on. Connect LED driver to the fixture before powering on the LED driver. -
Use UL recognized wire nuts to secure LED module Ground to building Ground (Earth).
-
Secure mounting plate to junction box with (2) junction box screws.
-
Secure LED module to mounting plate with (2) allen wrench set screws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>